Abstract:When a single-phase grounding fault occurs in a resonant grounding system, the determination of the fault location remains a significant challenge due to the small fault current and the instability of the grounding arc. In order to solve the problem of low protection sensitivity when a high-resistance grounding fault occurs in a resonant grounding system, this paper proposes a fault location method based on the combination of dynamic time warping (DTW) distance and fuzzy C-means (FCM) clustering. By analyzing the characteristics of the zero-sequence current upstream and downstream of the fault point when a single-phase grounding fault occurs in the resonant grounding system, it is concluded that the waveform similarity on both sides of the fault point is low. DTW distance can be used to measure the similarity of two time series, and has the characteristics of good fault tolerance and synchronization error tolerance. According to the rule that the DTW value of faulty section is much larger than that of nonfaulty sections, FCM clustering is used to classify the DTW value of each section. The membership degree matrix and cluster centers are obtained. In the membership degree matrix, the section corresponding to the data in a class of their own is the faulty section, and all other data correspond to the nonfaulty section; otherwise, it is a fault occurring at the end of the line. The simulation results of MATLAB/Simulink and the field data test show that the method can accurately locate the faulty section.

Fault Location Based on Synchronous Data of Both Ends in Non-effectively Grounded System

Single-phase-to-ground Fault Detection with Distributed Parameters Analysis in Non-Direct Grounded Systems

Fault Location Method for Distribution Network Based on Synchronous Measurement

Novel Fault Locating Method Based on Synchronized Voltage Phasor

A Two-Terminal Fault Location Algorithm Using Asynchronous Phasors Based on Distributed Parameter Model

A Novel Single-Ended Fault Location Method for Locating Double-Phase to Earth Faults

Sequential Data-Based Fault Location for Single-Line-to-Ground Fault in a T-Connection Power Line

A Fault Section Location Method for Small Current Neutral Grounding System Based on Energy Relative Entropy of Generalized S-Transform

Faulty Section Location Method Based on Dynamic Time Warping Distance in a Resonant Grounding System

A two-phase electric quantity-based fault location algorithm for power distribution systems

Single-end Fault Location Technique for DC Distribution Lines Based on Network Topology and Measured Traveling Waves

Locating of Multi-Phase Faults of Ungrounded Distribution System

Fault Location Analysis of Ungrounded Distribution System Based on Residual Voltage Distribution

Fault Location Method for Distribution Network Using an Additional Inductance Strategy

An Earth Fault Diagnosis Method Based On Online Dynamically Calculated Thresholds for Resonant Ground Systems

A Novel Fault Location Method for High Impedance Grounding Fault in Distribution Network

Fault Location Technology for Power System Based on Information About the Power Internet of Things

Faulty Feeder Detection for Single-Phase-to-Ground Fault in Distribution Networks Based on Transient Energy and Cosine Similarity

Location of Asymmetric Ground Fault Using Virtual Injected Current Ratio and Two-stage Recovery Strategy in Distribution Networks

Grounding fault test technology of distribution network based on zero sequence power direction judgment

Current Sag and Mismatch Based Earth Fault Location for Distribution Network with Renewable Energy Resources