Abstract:This paper establishes a transient equivalent circuit of cross‐line same‐phase successive grounding faults, and analyses the characteristics of zero‐sequence current. Then, a fault initiation criterion based on kurtosis theory and the Teager‐Kaiser energy operator (TKEO) is proposed. Finally, a method for faulty line detection based on cross‐correlation distance and transient energy is proposed and different fault conditions verify the effectiveness of proposed method. Currently, theoretical analysis of single‐phase grounding (SPG) faults in low‐current grounding systems has reached a high level of refinement, and the corresponding detection methods have matured. However, there is a significant lack of research on successive grounding (SG) faults, particularly in the area of detecting cross‐line same‐phase successive grounding (CSSG) faults in arc suppression coil grounding systems. To address these issues, a novel faulty line detection method based on transient characteristics of CSSG is proposed. Firstly, a transient equivalent circuit is established, and the characteristics of transient zero‐sequence current (ZSC) are theoretically analysed. Secondly, variational mode decomposition (VMD) is employed to extract low and high‐frequency information from intrinsic mode functions (IMFs). Subsequently, a fault initiation criterion based on kurtosis theory and the Teager‐Kaiser energy operator (TKEO) is proposed, which can accurately detect the occurrence time of secondary faults. Finally, a method for faulty line detection based on cross‐correlation distance (CCD) and transient energy (TE) is proposed. The results of PSCAD simulation under different conditions and field test affirm the accuracy of the analysis and the effectiveness of the proposed method.

A Fault Section Location Method for Small Current Neutral Grounding System Based on Energy Relative Entropy of Generalized S-Transform

Single-phase-to-ground Fault Detection with Distributed Parameters Analysis in Non-Direct Grounded Systems

Fault Location Based on Synchronous Data of Both Ends in Non-effectively Grounded System

Faulty Section Location Method Based on Dynamic Time Warping Distance in a Resonant Grounding System

Sequential Data-Based Fault Location for Single-Line-to-Ground Fault in a T-Connection Power Line

Faulty Feeder Identification Based on Data Analysis and Similarity Comparison for Flexible Grounding System in Electric Distribution Networks

A Novel Single-Ended Fault Location Method for Locating Double-Phase to Earth Faults

A Novel Fault Location Method for High Impedance Grounding Fault in Distribution Network

A new principle to detect the grounded line in a neutral point indirectly grounded power system based on the energy function

Faulty line detection for cross‐line same‐phase successive ground faults in distribution network based on transient characteristics

An Earth Fault Diagnosis Method Based On Online Dynamically Calculated Thresholds for Resonant Ground Systems

Faulty Feeder Detection for Single-Phase-to-Ground Fault in Distribution Networks Based on Transient Energy and Cosine Similarity

Grounding fault test technology of distribution network based on zero sequence power direction judgment

An online energy-tracking-based approach for fault-identification applies to the NUGS

A Method of Single Phase to Ground Fault Feeder Selection Based on Single Phase Current Traveling Wave for Distribution Lines

ANALYSIS ON TRANSIENT TRAVELING WAVE AND STUDY ON FAULT LINE SELECTION FOR DISTRIBUTION LINES

A Fault Location Method Based on Electromagnetic Transient Convolution Considering Frequency-Dependent Parameters and Lossy Ground

Earth Fault Detection Method in Non-solidly Earthed Network Based on the Increments of Phase Current

Faulty Feeder Selection and Segment Location Method for SPTG Fault in Radial MMC-MVDC Distribution Grid

Direction travelling waves based single-phase-to ground fault line section identification

Fault Location Based on Global Search of Minimum Phase Difference for High Voltage Transmission Lines