Abstract:The distribution network structure is complex, the scale is large, the fault rate is high, the fault resistance is relatively large, and the branch is quite a lot, so that the fault signal is hard to detect effectively and the accurate fault location is very difficult to realize. Although there are impedance method, traveling wave method and other fault location methods, these methods have their own conditions. Therefore, the method of artificial line inspection is often used to locate fault. Based on the distribution parameter model of the transmission line, this paper proposed a fault location method for multi-branch distribution line. In this method, the relationship between the voltage and current along the transmission line and at the endpoints of the line is deduced by the transmission line equations. The location of the fault point is obtained according to the voltages at fault point are equal, which are calculated by the voltage and current at two endpoints separately. This method is simple because in the case of known line parameters, it only needs to measure the voltage and current at each endpoint of the line synchronously. Through locating the single-phase ground fault in multi-branch distribution line, the results prove the correctness and accuracy of this method.

Fault Location Based on Global Search of Minimum Phase Difference for High Voltage Transmission Lines

A Novel Single-Ended Fault Location Method for Locating Double-Phase to Earth Faults

Fault Location Algorithm for HV Transmission Lines Immune to Saturation of Current Transformers

New Fault Location Method for HV T-connection. Transmission Lines

A Two-Terminal Fault Location Algorithm Using Asynchronous Phasors Based on Distributed Parameter Model

Fault Location for HV Three-terminal Transmission Lines

Research on a New Single-End Fault Location Method for Single-Phase Grounding Faults of Transmission Lines Through Transition Resistance

Transmission Line Fault Location Based on Improved Algorithm of Electromagnetic Time Reversal

A Novel Fault Location Method Suitable for Transmission Line with Multi Branches

Three Phase Transmission Line Fault Location Based on the Generalized Bergeron Model

Fault Location for Three-Terminal Transmission Lines Using Fault Voltage Sequence Components

A NOVEL PRINCIPLE OF SINGLE-ENDED LINE FAULT LOCATION TECHNIQUE FOR EHV TRANSMISSION SYSTEMS

Fault Location Method Based on Full Waveform Information for Distribution Networks

Fault Location Method for HVDC Transmission Lines on the Basis of the Distributed Parameter Model

Single-end Fault Location for High Impedance Arc Grounding Fault in Transmission Line

Phase Voltage and Current Fault Components Based Fault Segment Location Method Under Single-Phase Earth Fault in Distribution Network

Phase Current Fault Component Based Single-Phase Earth Fault Segment Location in Non-Solidly Earthed Distribution Networks

Locating of Multi-Phase Faults of Ungrounded Distribution System

Fault Location Analysis of Ungrounded Distribution System Based on Residual Voltage Distribution

New Accurate Fault Location Algorithm for Faults Between Two Lines of Double-Circuit Transmission Line Based on Differential Network

A Fault Location Method for Multi-branch Distribution Lines.