Abstract:Following the large‐scale integration of distributed power sources into distribution networks, fault currents undergo noticeable changes, which impacts the accuracy of conventional single‐phase ground fault algorithms. To tackle these issues, this work initially proposes an active distribution network ground fault protection algorithm based on the direction of extreme energy. Then, by establishing the electrical system structure and model of distribution network ground faults in the presence of distributed power sources, theoretical derivations and computations of transient zero‐sequence current frequency variations during fault instances are carried out. The characteristics of zero‐sequence current directions under distributed power sources integration are analysed, facilitating the design of a local ground fault determination algorithm grounded in the principle of energy extremum direction. This includes outlining fault determination and isolation procedures for ground fault monitoring equipment. Finally, through simulation testing, it is proven that the algorithm can reliably detect ground faults under both neutral point grounding configurations involving an arc suppression coil and ungrounded systems, across a range of transition resistances, varying numbers and capacities of distributed power sources connected, and differing grounding switch operation angles. After large‐scale distributed power sources are connected to the distribution network, the fault current undergoes noticeable changes, affecting the accuracy of traditional single‐phase grounding fault algorithms. Therefore, the objective of this paper is to address the impact of distributed power integration on the grounding algorithms of distribution networks. The main contribution is: by establishing an electrical system structure and model for distribution network grounding faults that include distributed generation (DG), theoretically deriving and calculating the transient zero‐sequence current frequency changes at the moment of fault, analysing the directional characteristics of zero‐sequence currents under DG connection conditions, designing a local grounding fault judgment algorithm based on energy extremum direction, and providing a fault judgment and isolation process for grounding fault monitoring devices. The results show: through simulation and experimentation, the algorithm was tested, and the method can reliably judge grounding faults under various transition resistances, different numbers and capacities of connected distributed power sources, and different grounding switch‐on angles. The applicability of the algorithm covers both methods of neutral grounding through an arc suppression coil and ungrounded neutrals, adapting to scenarios with or without DG connections.

An online energy-tracking-based approach for fault-identification applies to the NUGS

Single-phase-to-ground Fault Detection with Distributed Parameters Analysis in Non-Direct Grounded Systems

Faulty line detection for cross‐line same‐phase successive ground faults in distribution network based on transient characteristics

Faulty Feeder Identification Based on Data Analysis and Similarity Comparison for Flexible Grounding System in Electric Distribution Networks

Faulty Feeder Detection for Single-Phase-to-Ground Fault in Distribution Networks Based on Transient Energy and Cosine Similarity

A novel online monitoring method of ground fault in tree form distribution networks based on power line carrier devices

Power Distribution Network Ground Fault Location Algorithm Using On-Line Detectors

An Earth Fault Diagnosis Method Based On Online Dynamically Calculated Thresholds for Resonant Ground Systems

A new principle to detect the grounded line in a neutral point indirectly grounded power system based on the energy function

A Fault Section Location Method for Small Current Neutral Grounding System Based on Energy Relative Entropy of Generalized S-Transform

Fault Location Based on Synchronous Data of Both Ends in Non-effectively Grounded System

Ground fault protection algorithm of active distribution network based on energy extremum direction

An FTU-Based Method for Locating Single-Phase High-Impedance Faults Using Transient Zero-Sequence Admittance in Resonant Grounding Systems

ANALYSIS ON TRANSIENT TRAVELING WAVE AND STUDY ON FAULT LINE SELECTION FOR DISTRIBUTION LINES

Single-phase-to-ground fault section location in flexible resonant grounding distribution networks using soft open points

A novel fault locator for power distribution system with neutral non-effectively grounded

Grounding fault test technology of distribution network based on zero sequence power direction judgment

High-impedance faulty feeder detection for cross-country faults in distribution networks based on zero-sequence active power regulation

Faulty Feeder Detection Based on Fundamental Component Shift and Multiple-Transient-Feature Fusion in Distribution Networks

Sequential Data-Based Fault Location for Single-Line-to-Ground Fault in a T-Connection Power Line

Faulty feeder detection of single phase-to-ground fault for distribution networks based on improved K-means power angle clustering analysis