Abstract:Following the large‐scale integration of distributed power sources into distribution networks, fault currents undergo noticeable changes, which impacts the accuracy of conventional single‐phase ground fault algorithms. To tackle these issues, this work initially proposes an active distribution network ground fault protection algorithm based on the direction of extreme energy. Then, by establishing the electrical system structure and model of distribution network ground faults in the presence of distributed power sources, theoretical derivations and computations of transient zero‐sequence current frequency variations during fault instances are carried out. The characteristics of zero‐sequence current directions under distributed power sources integration are analysed, facilitating the design of a local ground fault determination algorithm grounded in the principle of energy extremum direction. This includes outlining fault determination and isolation procedures for ground fault monitoring equipment. Finally, through simulation testing, it is proven that the algorithm can reliably detect ground faults under both neutral point grounding configurations involving an arc suppression coil and ungrounded systems, across a range of transition resistances, varying numbers and capacities of distributed power sources connected, and differing grounding switch operation angles. After large‐scale distributed power sources are connected to the distribution network, the fault current undergoes noticeable changes, affecting the accuracy of traditional single‐phase grounding fault algorithms. Therefore, the objective of this paper is to address the impact of distributed power integration on the grounding algorithms of distribution networks. The main contribution is: by establishing an electrical system structure and model for distribution network grounding faults that include distributed generation (DG), theoretically deriving and calculating the transient zero‐sequence current frequency changes at the moment of fault, analysing the directional characteristics of zero‐sequence currents under DG connection conditions, designing a local grounding fault judgment algorithm based on energy extremum direction, and providing a fault judgment and isolation process for grounding fault monitoring devices. The results show: through simulation and experimentation, the algorithm was tested, and the method can reliably judge grounding faults under various transition resistances, different numbers and capacities of connected distributed power sources, and different grounding switch‐on angles. The applicability of the algorithm covers both methods of neutral grounding through an arc suppression coil and ungrounded neutrals, adapting to scenarios with or without DG connections.

Power Distribution Network Ground Fault Location Algorithm Using On-Line Detectors

Single-phase-to-ground Fault Detection with Distributed Parameters Analysis in Non-Direct Grounded Systems

A novel online monitoring method of ground fault in tree form distribution networks based on power line carrier devices

Grounding Failure Detection Based on Wavelets Method in Resonant Grounded Power Distribution System

The Algorithm for Locating Ground Faults on Power Distribution Based on Electromagnetic Calculations

ANALYSIS IN FREQUENCY DOMAIN FOR LOCATIN G GROUND FAULTIN THE BRANCHES OF POWER DISTRIBUTION NETWORK

Ground fault protection algorithm of active distribution network based on energy extremum direction

Grounding fault test technology of distribution network based on zero sequence power direction judgment

Design of Online Intelligent Detection System for Power Quality and Fault Identification in Distribution Networks

An online energy-tracking-based approach for fault-identification applies to the NUGS

An Earth Fault Diagnosis Method Based On Online Dynamically Calculated Thresholds for Resonant Ground Systems

Frequency Domain Analysis for Line-to-ground Fault Location in Frequency-Dependent Distribution Lines

A new principle to detect the grounded line in a neutral point indirectly grounded power system based on the energy function

A Novel Fault Location Method for High Impedance Grounding Fault in Distribution Network

Fault Location Technology for Power System Based on Information About the Power Internet of Things

Fault Detection and Location of 35 kV Single-Ended Radial Distribution Network Based on Traveling Wave Detection Method

Analysis and Detection of High Impedance Grounding Fault in Neutral Point Effectively Grounding Distribution Network

Fault Location Based on Synchronous Data of Both Ends in Non-effectively Grounded System

Locating of Multi-Phase Faults of Ungrounded Distribution System

Single-phase Grounding Fault Line Selection Method of Ring Distribution Network Based on Classification Method

Fault Location Method for Distribution Network Based on Synchronous Measurement