Single-phase ground fault location method for distribution network based on traveling wave time-frequency characteristics
Zhao Jianwen,Hou Hui,Gao Yu,Huang Yongping,Gao Shuping,Lou Jianan
DOI: https://doi.org/10.1016/j.epsr.2020.106401
IF: 3.818
2020-09-01
Electric Power Systems Research
Abstract:<p>The traditional traveling wave fault location methods only consider the information about time domain or frequency domain characteristics, so it is difficult to ensure the location accuracy. Through the research of relationship between traveling wave characteristic parameters and frequency, this paper proposes a single-phase grounding fault location method based on traveling wave time-frequency characteristics. Firstly, determine the time during which the traveling wave reaches the busbar by using the quadratic B-spline wavelet analysis modulus maximum detection algorithm with denoising factor.. Then, according to the improved matrix pencil algorithm, extracte the frequency of traveling wave arriving at the bus measuring point, and the corresponding velocity of incident wave is obtained. Finally, the fault distance can be calculated using the location equation of modulus wave velocity difference. The simulation results show that this method proposed in this paper has higher accuracy than the traditional method, and in the terms of different grounding resistance, fault initial angle and fault distance, the error of fault location is smaller.</p>
engineering, electrical & electronic