Abstract:Single-phase high-resistance grounding fault is very typical in resonant grounding distribution network, while the fault detection and line selection in field application is not an easy task for traditional methods since both the type of state parameter and the data amount is not sufficient. To overcome such limitations, this paper proposes an approach which reconstruction the initial criterion of fault occurrence and fault line selection criterion. Firstly, a method combining 15% traditional phase voltage with the sum of zero-sequence voltage gradient is proposed as the initial criterion of fault occurrence to improve the speed of line selection device. After that, the transient process of high-resistance grounding of a resonant grounding system is analyzed according to the difference in impedance characteristics between the high and the low-frequency lines, and the line selection criterion is constructed according to the correlation difference between the current and voltage derivative waveforms on high- and low-frequency lines. Finally, the adaptability of the proposed method is verified through simulation. The results show that the proposed method can deal with high-resistance grounding fault in complex fault conditions, and can also meet the speed requirements of line selection.

Fault line selection based on current traveling waves and wavelet transform for non-solid-grounded system

Single-phase-to-ground Fault Detection with Distributed Parameters Analysis in Non-Direct Grounded Systems

ANALYSIS ON TRANSIENT TRAVELING WAVE AND STUDY ON FAULT LINE SELECTION FOR DISTRIBUTION LINES

A new principle of fault line selection for distribution

Direction travelling waves based single-phase-to ground fault line section identification

Grounding Failure Detection Based on Wavelets Method in Resonant Grounded Power Distribution System

Study of Fault Line Selection Using Single-Phase Current Traveling Waves

New Approach of Fault Detection and Fault Phase Selection Based on Initial Current Traveling Waves

Faulted Feeder Selection in Neutral Non-Effectively Grounded Distribution System Using Single-Phase Current Traveling Wave

A Method of Single Phase to Ground Fault Feeder Selection Based on Single Phase Current Traveling Wave for Distribution Lines

Test of Fault Line Selector Based on Current Traveling Wave

Adaptive Traveling Waves Based Protection of Distribution Lines

Fault Line Identification Of Single Line To Ground Fault For Non-Effectively Grounded Distribution Networks With Double-Circuit Lines

A Novel Current Travelling Wave Based Single-Ended Fault Location Method for Locating Single-Phase-to-ground Fault of Transmission Line

Fault Classification and Faulted-Phase Selection Based on the Initial Current Traveling Wave

Traveling Waves Based Fault Line Selection Using Sparse Representation

High-Resistance Grounding Fault Detection and Line Selection in Resonant Grounding Distribution Network

Implementation and test of fault line selector using zero module current travelling waves

Technique of fault line selecton for no direct ground neutral system

Single-phase Grounding Fault Line Selection Method of Ring Distribution Network Based on Classification Method

Faulty feeder selection based on improved Hough transform in resonant grounded distribution networks