Abstract:Current travelling wave based single-ended fault location method needs to recognize the travelling waves propagating from the fault direction as well as the travelling wave reflected from the fault point or remote-end bus. This paper firstly compares the current travelling waves of the fault line and the longest health line connected to the local bus based on dyadic wavelet transform to obtain the current travelling waves propagating from the fault direction. Secondly, based on the cross transmission phenomenon of modal travelling waves under the scenario of single-phase-to-ground fault, the arrival sequence relation and the polarity relation of aerial-modal component and zero-to-aerial-modal component (i.e. cross transmission component) of the current travelling waves reflected from the fault point and the remote-end bus are investigated and the source of the second current travelling wave propagating from the fault direction is identified. Thirdly, the first and the second current travelling waves propagating from the fault direction are utilised to locate the single-phase-to-ground fault. Finally, a large number of EMTP based simulation cases are used to test and validate the proposed fault location method.

Study of Fault Line Selection Using Single-Phase Current Traveling Waves

Fault line selection based on current traveling waves and wavelet transform for non-solid-grounded system

Implementation and test of fault line selector using zero module current travelling waves

Direction travelling waves based single-phase-to ground fault line section identification

ANALYSIS ON TRANSIENT TRAVELING WAVE AND STUDY ON FAULT LINE SELECTION FOR DISTRIBUTION LINES

Test of Fault Line Selector Based on Current Traveling Wave

A Method of Single Phase to Ground Fault Feeder Selection Based on Single Phase Current Traveling Wave for Distribution Lines

Research on Fault Line Selection of Single-Phase Earth Fault Through Extinction Coil

New Fault Phase Selection Method for Line Zero-Sequence Current Differential Protection

A Novel Current Travelling Wave Based Single-Ended Fault Location Method for Locating Single-Phase-to-ground Fault of Transmission Line

New Approach of Fault Detection and Fault Phase Selection Based on Initial Current Traveling Waves

A new principle of fault line selection for distribution

An Adaptive Fault Line Selection Method Based on Wavelet Packet Comprehensive Singular Value for Small Current Grounding System

A Novel Approach to Faulted-Phase Selection Using Current Traveling Waves and Wavelet Analysis

Traveling Waves Based Fault Line Selection Using Sparse Representation

Technique of fault line selecton for no direct ground neutral system

Detecting a fault line under a single-phase to ground of distribution network based on analysis of multi-frequency bands

A New Approach to Identifying Faulty Lines in Distribution Systems Based on Traveling Wave Refraction and Coupling

Study of fault location for parallel transmissions lines using one terminal current traveling waves

Research on fault line selection method based on steady state variables

Research on Detecting Fault Traveling Wave and Selecting Fault Line and Fault Phase Based on Wavelet Theory