Abstract:When a single-phase grounding fault occurs in a resonant grounding system, the determination of the fault location remains a significant challenge due to the small fault current and the instability of the grounding arc. In order to solve the problem of low protection sensitivity when a high-resistance grounding fault occurs in a resonant grounding system, this paper proposes a fault location method based on the combination of dynamic time warping (DTW) distance and fuzzy C-means (FCM) clustering. By analyzing the characteristics of the zero-sequence current upstream and downstream of the fault point when a single-phase grounding fault occurs in the resonant grounding system, it is concluded that the waveform similarity on both sides of the fault point is low. DTW distance can be used to measure the similarity of two time series, and has the characteristics of good fault tolerance and synchronization error tolerance. According to the rule that the DTW value of faulty section is much larger than that of nonfaulty sections, FCM clustering is used to classify the DTW value of each section. The membership degree matrix and cluster centers are obtained. In the membership degree matrix, the section corresponding to the data in a class of their own is the faulty section, and all other data correspond to the nonfaulty section; otherwise, it is a fault occurring at the end of the line. The simulation results of MATLAB/Simulink and the field data test show that the method can accurately locate the faulty section.

Single Phase Grounding Fault Location Based on Frequency Domain Characteristics of Fault Current

Single-phase-to-ground Fault Detection with Distributed Parameters Analysis in Non-Direct Grounded Systems

Single-phase ground fault location method for distribution network based on traveling wave time-frequency characteristics

Grounding Failure Detection Based on Wavelets Method in Resonant Grounded Power Distribution System

Faulted feeder identification and location for a single line-to-ground fault in ungrounded distribution system based on principal frequency component

Research on single-phase grounding fault location technology in distribution networks based on impedance method

Fault Location Analysis of Ungrounded Distribution System Based on Residual Voltage Distribution

Single-phase-to-ground fault section location in flexible resonant grounding distribution networks using soft open points

Frequency Domain Analysis for Line-to-ground Fault Location in Frequency-Dependent Distribution Lines

Locating of Multi-Phase Faults of Ungrounded Distribution System

A Novel Single-Ended Fault Location Method for Locating Double-Phase to Earth Faults

High-Resistance Grounding Fault Detection and Line Selection in Resonant Grounding Distribution Network

Fault Location Based on Synchronous Data of Both Ends in Non-effectively Grounded System

A Novel Current Travelling Wave Based Single-Ended Fault Location Method for Locating Single-Phase-to-ground Fault of Transmission Line

A Single-Phase to Ground Fault Location Method Based on Last-Squares Parameter Estimation in Arc-Suppression-Coil Grounding System

Study on Locating Techniques of Single-phase Grounding Fault in Distribution Network

Fault Location Method for Distribution Network Based on Synchronous Measurement

Fault Location Based on Global Search of Minimum Phase Difference for High Voltage Transmission Lines

A novel fault locator for power distribution system with neutral non-effectively grounded

A Novel Fault Location Method for High Impedance Grounding Fault in Distribution Network

Faulty Section Location Method Based on Dynamic Time Warping Distance in a Resonant Grounding System