Abstract:With the increasing complexity of distribution network structures originating from the high penetration of renewable energy and responsive loads, fast and accurate fault location technology for distribution networks is a prerequisite for rapid isolation of faults and restoration of the power supply. In this paper, a fault location method based on community graph depth-first traversal is proposed for fast location of single-phase ground faults in distribution networks. First, this paper defines the fault graph weight of the vertices in the distribution network graph model, which can be used to reflect the topology of the vertices and fault points as well as the fluctuation of the vertices' currents. Then, the vertices on the graph model are clustered by using an improved parallel louvain method (IPLM). Finally, the community formed by IPLM is used as the smallest unit for depth-first traversal to achieve fast and accurate location of the fault section. The paper develops a distribution network graph model of IEEE 33-bus system on the graph database for testing. And three other methods are selected for comparison with IPLMDF. The test results show that IPLMDF can achieve fast and accurate fault location when half of the nodes in the distribution network are equipped with D-PMUs. When some of the D-PMUs lose time synchronization, it is still possible to locate the fault section, and at the same time, the locating results can be avoided by falling into local optimal solutions.

Single Line-to-ground Fault Location and Information Modeling Based on the Interaction between Intelligent Distribution Equipment

An adaptative differential zone fault locating scheme for distribution system with DGS

Regionalized Fault Line in Distribution Networks Based on an Improved SSA-VMD and Multi-Scale Fuzzy Entropy

Single Line-to-Ground Fault Type Multilevel Classification in Distribution Network Using Realistic Recorded Waveform

Fast single-phase fault location method based on community graph depth-first traversal for distribution network

An Earth Fault Diagnosis Method Based On Online Dynamically Calculated Thresholds for Resonant Ground Systems

Fault Location Method for Distribution Network Based on Synchronous Measurement

Research on single-phase grounding fault location technology in distribution networks based on impedance method

Faulty feeder selection based on improved Hough transform in resonant grounded distribution networks

Single-phase Grounding Fault Line Selection Method of Ring Distribution Network Based on Classification Method

Faulty Line-Section Identification Method for Distribution Systems Based on Fault Indicators

A Traveling-Wave-based Line Protection Strategy Against Single-Line-to-ground Faults in Active Distribution Networks

A Fully Decentralized Multi-Agent Fault Location and Isolation for Distribution Networks With DGs

Fault Location Based on Synchronous Data of Both Ends in Non-effectively Grounded System

Fault location based on variable mode decomposition and kurtosis calibration in distribution networks

Fault Location Technology for Power System Based on Information About the Power Internet of Things

Fault Line Identification Of Single Line To Ground Fault For Non-Effectively Grounded Distribution Networks With Double-Circuit Lines

Study on fault line detection methods based on multi‐feature fusion in distribution systems

Study on Locating Techniques of Single-phase Grounding Fault in Distribution Network

Sequential Data-Based Fault Location for Single-Line-to-Ground Fault in a T-Connection Power Line

Multi-agent System-Assisted Fault Section Location Scheme for Distribution Networks with DFIG-based Wind DGs