Abstract:Ce1-xZrxO2 (x = 0-0.8) nanoparticulate powders were prepared via a mild urea hydrolysis based hydrothermal method through homogeneous nucleation at 413 K followed by calcination at 773 or 1173 K. X-ray fluorescence (XRF) and energy-dispersive X-ray analysis (EDAX) measurements testify to the good stoichiometric homogeneity of Ce and Zr cations in the as-obtained Ce1-xZrxO2 products. X-ray photoelectron spectroscopy (XPS) and ultraviolet-visible (UV-vis) spectra exhibit that both surface and bulk ratios of Ce3+ to Ce4+ for the as-prepared Ce1-xZrxO2 nanocrystals increased with the zirconium content x. Powder X-ray diffraction (PXRD) patterns and Raman spectra demonstrate that the present Ce1-xZrxO2 samples were single-phase solid solutions with good structural homogeneity and high thermal stability up to 1273 K, and those with x = 0.4-0.6 retained a pseudocubic structure (t" phase) due to the small crystallite size effect. Transmission electron microscopy (TEM) micrographs reveal that the as-prepared CeO2-ZrO2 nanocrystals were highly crystallized with narrow size distribution. Nitrogen adsorption measurements show that the BET specific surface areas of the Ce1-xZrxO2 powders were improved by the incorporation of ZrO2. The PXRD data and high-resolution TEM (HRTEM) images illuminate that the as-prepared and as-calcined Ce1-xZrxO2 (x = 0.4-0.6) powders kept a rather high strain level in the crystal lattice. The lattice strains in our Ce1-xZrxO2 catalysts show a linear relationship with their oxygen storage capacity (OSC) values. This linear correlation is explained on the basis of qualitative structural and defective analysis, and might find use in the screening and design of better-performing three-way catalysts (TWCs). The highest CO-OSC values of the studied CeO2-ZrO2 catalysts appeared for Ce0.5Zr0.5O2 (543 mumol of CO g(-1) at 773 K and 628 mumol of CO g(-1) at 973 K).

The Self-Catalytic Role of Zirconium N-Propoxide in Sol-Gel Syntheses of ZrO<sub>2</sub>/Y<sub>2</sub>O<sub>3</sub>-CeO<sub>2</sub> Compound Powders

The Self-Catalytic Role Of Zirconium N-Propoxide In Sol-Gel Syntheses Of Zro2/Y2o3-Ceo2 Compound Powders

A General Propylene Epoxide-assisted Sol-Gel Route for the Synthesis of ZrO2-SnO2 Composite Sols

Synthesis, Characterization and Application of Submicron ZrSiO4 Powder Via Sol-Gel-microemulsion-hydrothermal Method

Preparation of Zirconia Powders by Sol-gel Process

Synthesis and Characterization of Doped Nano-Sized Ceria–zirconia Solid Solutions

Synthesis of Monolithic Zirconia with Macroporous Bicontinuous Structure Via Epoxide-Driven Sol–gel Process Accompanied by Phase Separation

Preparation of macroporous zirconia monoliths from ionic precursors via an epoxide-mediated sol-gel process accompanied by phase separation

Preparation and Characterization of Ceria-Zirconia Ceramics Using a Sol-Gel Process

Transformation of CO2 and Glycerol to Glycerol Carbonate over CeO2ZrO2 Solid Solution —— Effect of Zr Doping

General and facile synthesis of ceria-based solid solution nanocrystals and their catalytic properties

Physical Chemistry of Controlled-Hydrolysis of Propanol Zirconia Doped with Yttrium Nitrite

Effects of Zr on the Precursor Architecture and High-Temperature Nanostructure Evolution of Sioc Polymer-Derived Ceramics

The influence of H2O2 on the properties of CeO2-ZrO2 mixed oxides

Elucidation of Ce/Zr ratio effects on the physical properties and catalytic performance of CuOx/CeyZr1-yO2 catalysts

Preparation of Macroporous Zirconia Monoliths via Sol-Gel Process Accompanied by Phase Separation

Preparation and CO 2 Capture Properties of Nanocrystalline Li 2 ZrO 3 Via an Epoxide-Mediated Sol–gel Process

Urea-Based Hydrothermally Derived Homogeneous Nanostructured Ce1-Xzrxo2 (X=0-0.8) Solid Solutions: A Strong Correlation Between Oxygen Storage Capacity and Lattice Strain

Sol-Gel Synthesis of Yttria Stabilized Zirconia Membranes Through Controlled Hydrolysis of Zirconium Alkoxide

Preparation of Zirconia/Organosilicone Thin Film by Sol-Gel Method

Effect of Preparation Method on the Surface and Redox Properties of Ce0.67zr0.33o2 Mixed Oxides