Abstract:Hypothesis: Zirconia microparticles produced by sol-gel synthesis have great potential for photonic applications. To this end, identifying synthetic methods that yield reproducible control over size uniformity is important. Phase transformations during thermal cycling can disintegrate the particles. Therefore, understanding the parameters driving these transformations is essential for enabling high-temperature applications. Particle morphology is expected to influence particle processability and stability. Yttria-doping should improve the thermal stability of the particles, as it does in bulk zirconia. Experiments: Zirconia and YSZ particles were synthesized by improved sol-gel approaches using fatty acid stabilizers. The particles were heated to 1500 °C, and structural and morphological changes were monitored by SEM, ex situ XRD and high-energy in situ XRD. Findings: Zirconia particles (0.4-4.3 μm in diameter, 5-10% standard deviation) synthesized according to the modified sol-gel approaches yielded significantly improved monodispersities. As-synthesized amorphous particles transformed to the tetragonal phase at ∼450 °C with a volume decrease of up to ∼75% and then to monoclinic after heating from ∼650 to 850 °C. Submicron particles disintegrated at ∼850 °C and microparticles at ∼1200 °C due to grain growth. In situ XRD revealed that the transition from the amorphous to tetragonal phase was accompanied by relief in microstrain and the transition from tetragonal to monoclinic was correlated with the tetragonal grain size. Early crystallization and smaller initial grain sizes, which depend on the precursors used for particle synthesis, coincided with higher stability. Yttria-doping reduced grain growth, stabilized the tetragonal phase, and significantly improved the thermal stability of the particles.

Physical Chemistry of Controlled-Hydrolysis of Propanol Zirconia Doped with Yttrium Nitrite

Fabrication and Characterization of Y2O3 Stabilized ZrO2 Films Deposited with Aerosol-Assisted MOCVD

Sol-Gel Synthesis of Yttria Stabilized Zirconia Membranes Through Controlled Hydrolysis of Zirconium Alkoxide

A General Propylene Epoxide-assisted Sol-Gel Route for the Synthesis of ZrO2-SnO2 Composite Sols

Preparation of Zirconia Powders by Sol-gel Process

Preparation of Porous YSZ Monoliths via Sol-gel Process Accompanied by Phase Separation

Synthesis of Monolithic Zirconia with Macroporous Bicontinuous Structure Via Epoxide-Driven Sol–gel Process Accompanied by Phase Separation

Ethanol-induced formation of precursor for 8mol% Yttria-stabilized zirconia: Towards the production of well-dispersed, easily sintering, and high-conductivity nano-powders

Synthesis and Characterization of Doped Nano-Sized Ceria–zirconia Solid Solutions

Synthesis and thermal stability of zirconia and yttria-stabilized zirconia microspheres

Preparation of yttria stabilized zirconia membranes on porous substrates by a dip-coating process

Formation and Rate Processes of Y2o3 Stabilized Zro2 Thin Films from Zr(Dpm)(4) and Y(Dpm)(3) by Cold-Wall Aerosol-Assisted Mocvd

Nano-dispersed yttria-stabilized zirconia powder: Phase, morphology, and conductivity investigation with different chelating agents via a modified sol-gel method

The Self-Catalytic Role of Zirconium N-Propoxide in Sol-Gel Syntheses of ZrO<sub>2</sub>/Y<sub>2</sub>O<sub>3</sub>-CeO<sub>2</sub> Compound Powders

Solvent Effects on the Solvothermal Synthesis of PureMonoclinic and Tetragonal Zirconia Nanoparticles

Preparation of Yttria Stabilized Zirconia Ultrafiltration Membranes with Inorganic Precursors

Phase Composition Controllable Preparation of Zirconia Nanocrystals Via Solvothermal Method

The Self-Catalytic Role Of Zirconium N-Propoxide In Sol-Gel Syntheses Of Zro2/Y2o3-Ceo2 Compound Powders

The Preparation,Stability of Zirconium Sol and Characteristics of ZrO_2 Powder

Preparation and Electronic Properties of Nanometer YSZ

Preparation and Characterization of Nanoscale Y-TZP Powder by Heterogeneous Azeotropic Distillation