Abstract:Wafer‐scale deposition of high‐κ gate dielectric on 2D materials is crucial for applications in nano‐electronics, and antimony trioxide (Sb2O3) has shown promising results. It is shown that the choice of contact is critical, as the chemistry at the Sb2O3/contact interface dictates the dielectric performance. Using Ti and Au as contacts, transmission electron microscopy analysis reveals that Ti scavenges oxygen from the Sb2O3, while this interfacial reaction is completely absent for Au contacts. Wafer‐scale deposition of high‐κ gate dielectrics compatible with atomically thin van der Waals layered semiconductors (e.g., MoS2, WS2, WSe2) is urgently needed for practical applications of field effect transistors based on 2D materials. A study on a high‐κ molecular crystal antimony trioxide (Sb2O3) gate dielectric examined the role of electrode material on dielectric degradation and breakdown. It is demonstrated that the thin films of Sb2O3 can be uniformly deposited on a wafer scale. The current–voltage (I–V) curves show tightly controlled distributions of both leakage current and breakdown voltage. Electrical measurements reveal that defects are generated gradually upon electrical stressing. The evaluation of degradation is based on charge trapping, stress‐induced leakage current, and dielectric breakdown measurements. The breakdown voltage distribution follows a tight monomodal Weibull distribution suggesting a high quality of the film. Comparing Ti and Au as gate electrodes, both the breakdown field and the tunnel current are affected by the choice of electrode material. Transmission electron microscopy reveals that the chemistry at the electrode/Sb2O3 interface plays an important role and that Ti scavenges oxygen from the Sb2O3, forming a defective oxide layer at the Ti/Sb2O3 interface. For the Au electrode, this interfacial reaction is completely absent, improving the dielectric performance.

Reliability of Ultrathin High-κ Dielectrics on Chemical-vapor Deposited 2D Semiconductors

Reliability of Ultrathin High- Dielectrics on 2D Semiconductors

Integrating high-quality dielectrics with one-nanometer equivalent oxide thickness on two-dimensional electronic devices

Scalable Integration of Hybrid High-Κ Dielectric Materials on Two-Dimensional Semiconductors

Uniform and ultrathin high-κ gate dielectrics for two-dimensional electronic devices

Wafer-scale high-κ dielectrics for two-dimensional circuits via van der Waals integration

Epitaxial Integration of Transferable High-κ Dielectric and 2D Semiconductor

Liquid Metal Oxide-assisted Integration of High-k Dielectrics and Metal Contacts for Two-Dimensional Electronics

Single-crystalline van der Waals layered dielectric with high dielectric constant

Janus Electronic Devices with Ultrathin High-κ Gate Dielectric Directly Integrated on 1T'-Mote2.

Ultimate dielectric scaling of 2D transistors via van der Waals metal integration

Crystalline Complex Oxide Membrane: Sub-1 nm CET Dielectrics for 2D Transistors

Vertically grown ultrathin Bi 2 SiO 5 as high- κ single-crystalline gate dielectric

Ultrathin Van Der Waals Lanthanum Oxychloride Dielectric for 2D Field-Effect Transistors

Vertically Grown Ultrathin Bi2SiO5 As High-Κ Single-Crystalline Gate Dielectric.

Ultrathin Van Der Waals Lanthanum Oxychloride Dielectric for Two‐Dimensional Field‐Effect Transistors

Low-defect-density WS 2 by Hydroxide Vapor Phase Deposition

Electrodes for High‐κ Molecular Crystal Antimony Trioxide Gate Dielectrics for 2D Electronics

Janus Electronic Devices with Ultrathin High-κ Gate Dielectric Directly Integrated on 1T'-MoTe 2

High-Fidelity Transfer of 2D Semiconductors and Electrodes for Van Der Waals Devices