Abstract:As MOSFET devices are scaled down to below 100nm, the gate oxide thickness is required below 2nm. Conventional SiO2 gate dielectric will be replaced due to excessive leakage and poor reliabilit y. Thus, high dielectrics constant (K) gate dielectrics are being studied as an alternative. High-K dielectrics materials such as CeO2, Y2O3, Ta2O5, HfO2, ZrO2, TiO2, Al2O3, SrTiO3(STO), and BaSrTiO3(BST) have are studied . Among them, HfO2 is a promising candidate due to its thermodynamic stabil ity on Si, high dielectric constant ( 25), and relatively large band gap (5.68eV). In the paper, ultra-thin HfO2 gate dielectrics films were fabricated, electrical and reliabili ty properties such as capacitance-voltage (C-V), current-voltage (I-V), stress induce leakage current (SILC) effects and breakdown characteristics were studied. In the experiment, HfO2 capacitor samples have been fabricated using the following process. P-type (100) sili con substrates with 5-8 cm resistivity were cleaned using H2SO4:H2O2 (2:1) solution and HF dip. Thin HfO2 layers were following deposited at room temperature by ion beam sputtering a sintered HfO2 target. Then they were annealed under various temperatures and ambient. After annealing, Pt top electrodes were deposited by sputtering. The area of the capacitors was 5 10cm. The C-V and I-V curves were measured using HP4156B semiconductor parameter analyzer and Keithley590 C-V analyzer. Figure 1 shows the capacitance-voltage (C-V) curves of HfO2 gate dielectrics. The largest value of measured capacitance density in accumulation is Cmax/A=11.6fF/ m. The equivalent oxide thickness (EOT) is about 2.9nm. Comparing capacitances of various annealing temperatures, the capacitance of the sample annealed at 400 is highest. With increase annealed temperatures, EOT increased. Figure 2 shows the current-voltage (I-V) characteristics of HfO2 gate dielectrics. The leakage current of the sample annealed at 800 is lowest, which is about 3.09 10A/cm at –1.5V gate voltage. No distinct SILC effect is obtained. The leakage current of the sample annealed at 400 after 1×10C/cm stress has a very lit tle diversification. With increase annealed temperatures, the leakage current and SILC effect reduced. Figure 3 shows breakdown characteristics of HfO2 dielectrics. The breakdown electric field of HfO2 dielectrics is more than 2×10MV/cm. With increase annealing temperatures, the breakdown voltages decreased. Consequently, ultra-thin HfO2 gate dielectrics (EOT<3nm) were fabricated. All samples annealed under various temperatures and N2 ambient have good electrical characteristic and reliabili ty. With increase annealing temperatures, EOT of increased, the leakage current and SILC effect reduced, the breakdown voltages decreased. References: [1] E.P. Gusev, E. Carier, D.A. Buchanan, M. Gribelyuk, M. Copel, H. Okorn-Schmidt, and C.D. Emic, Microelectronic Engineering 59(2001) 341-349 [2] Wen-jie Qi, Renee Nieh, Byoung Hun Lee, Laegu Kang, Yongjoo Jeon, and Jack C. Lee, Applied Physics Letters, 2000, 77(20): 3269-3271 [3] G.D. Wilk, and R.M. Wallace, Applied Physics Letters, 1999, 74(19): 2854-2856 [4] Kevin X. Zhang, Carlton M. Osbun, IEEE Trans. Electron Devices, 42(12), 1995, 2181-2188 [5] G.D. Wilk, R.M. Wallace, J.M. Anthony, Applied Physics Review, 2001, 89(10): 5243-5275

Reliability of Ultrathin High- Dielectrics on 2D Semiconductors

Reliability of Ultrathin High-κ Dielectrics on Chemical-vapor Deposited 2D Semiconductors

Integrating high-quality dielectrics with one-nanometer equivalent oxide thickness on two-dimensional electronic devices

Wafer-scale high-κ dielectrics for two-dimensional circuits via van der Waals integration

Scalable Integration of Hybrid High-Κ Dielectric Materials on Two-Dimensional Semiconductors

Uniform and ultrathin high-κ gate dielectrics for two-dimensional electronic devices

Liquid Metal Oxide-Assisted Integration of High-k Dielectrics and Metal Contacts for Two-Dimensional Electronics

Reliability characteristics of high-K gate dielectrics HfO2 in metal-oxide semiconductor capacitors

Improved Integration of Ultra-Thin High-K Dielectrics in Few-Layer Mos2 Fet by Remote Forming Gas Plasma Pretreatment

Explore of exfoliable multifunctional high-k two-dimensional oxides

Reliability Studies of Barrier Layers for Cu/PAE Low-K Interconnects.

Janus Electronic Devices with Ultrathin High-κ Gate Dielectric Directly Integrated on 1T'-Mote2.

Electrical and Reliability Characteristics of High-Κ HfO 2 Gate Dielectrics

Crystalline Complex Oxide Membrane: Sub-1 nm CET Dielectrics for 2D Transistors

Electrodes for High‐κ Molecular Crystal Antimony Trioxide Gate Dielectrics for 2D Electronics

Epitaxial Integration of Transferable High-κ Dielectric and 2D Semiconductor

Vertically Grown Ultrathin Bi2SiO5 As High-Κ Single-Crystalline Gate Dielectric.

Single-crystalline van der Waals layered dielectric with high dielectric constant

Vertically grown ultrathin Bi 2 SiO 5 as high- κ single-crystalline gate dielectric

Ultimate dielectric scaling of 2D transistors via van der Waals metal integration