Abstract:Wafer‐scale deposition of high‐κ gate dielectric on 2D materials is crucial for applications in nano‐electronics, and antimony trioxide (Sb2O3) has shown promising results. It is shown that the choice of contact is critical, as the chemistry at the Sb2O3/contact interface dictates the dielectric performance. Using Ti and Au as contacts, transmission electron microscopy analysis reveals that Ti scavenges oxygen from the Sb2O3, while this interfacial reaction is completely absent for Au contacts. Wafer‐scale deposition of high‐κ gate dielectrics compatible with atomically thin van der Waals layered semiconductors (e.g., MoS2, WS2, WSe2) is urgently needed for practical applications of field effect transistors based on 2D materials. A study on a high‐κ molecular crystal antimony trioxide (Sb2O3) gate dielectric examined the role of electrode material on dielectric degradation and breakdown. It is demonstrated that the thin films of Sb2O3 can be uniformly deposited on a wafer scale. The current–voltage (I–V) curves show tightly controlled distributions of both leakage current and breakdown voltage. Electrical measurements reveal that defects are generated gradually upon electrical stressing. The evaluation of degradation is based on charge trapping, stress‐induced leakage current, and dielectric breakdown measurements. The breakdown voltage distribution follows a tight monomodal Weibull distribution suggesting a high quality of the film. Comparing Ti and Au as gate electrodes, both the breakdown field and the tunnel current are affected by the choice of electrode material. Transmission electron microscopy reveals that the chemistry at the electrode/Sb2O3 interface plays an important role and that Ti scavenges oxygen from the Sb2O3, forming a defective oxide layer at the Ti/Sb2O3 interface. For the Au electrode, this interfacial reaction is completely absent, improving the dielectric performance.

Electrodes for High‐κ Molecular Crystal Antimony Trioxide Gate Dielectrics for 2D Electronics

A Single‐Crystal Antimony Trioxide Dielectric for 2D Field‐Effect Transistors

Reliability of Ultrathin High-κ Dielectrics on Chemical-vapor Deposited 2D Semiconductors

A native oxide high-kappa gate dielectric for two-dimensional electronics

A wafer-scale van der Waals dielectric made from an inorganic molecular crystal film

Uniform and ultrathin high-κ gate dielectrics for two-dimensional electronic devices

Scalable Integration of Hybrid High-Κ Dielectric Materials on Two-Dimensional Semiconductors

Vertically grown ultrathin Bi 2 SiO 5 as high- κ single-crystalline gate dielectric

The interfaces of lanthanum oxide-based subnanometer EOT gate dielectrics.

Advances in atomic layer deposited high-κ inorganic materials for gate dielectrics engineering of two-dimensional MoS2 field effect transistors

Reliability of Ultrathin High $-\Mathcal{k}$ Dielectrics on 2D Semiconductors

Probing Gate Dielectrics for Two-Dimensional Electronics at Atomistic Scale Using Transmission Electron Microscope

Uniform High-k Amorphous Native Oxide Synthesized by Oxygen Plasma for Top-Gated Transistors

Single-crystalline metal-oxide dielectrics for top-gate 2D transistors

Integrating high-quality dielectrics with one-nanometer equivalent oxide thickness on two-dimensional electronic devices

A native oxide high-κ gate dielectric for two-dimensional electronics

Single-crystalline High-κ GdOCl Dielectric for Two-Dimensional Field-Effect Transistors

Wafer-scale high-κ dielectrics for two-dimensional circuits via van der Waals integration

Single-crystalline van der Waals layered dielectric with high dielectric constant

Ultrathin Van Der Waals Lanthanum Oxychloride Dielectric for 2D Field-Effect Transistors

A Single-Crystalline Native Dielectric for Two-Dimensional Semiconductors with an Equivalent Oxide Thickness below 0.5 Nm