Abstract:Wafer‐scale deposition of high‐κ gate dielectric on 2D materials is crucial for applications in nano‐electronics, and antimony trioxide (Sb2O3) has shown promising results. It is shown that the choice of contact is critical, as the chemistry at the Sb2O3/contact interface dictates the dielectric performance. Using Ti and Au as contacts, transmission electron microscopy analysis reveals that Ti scavenges oxygen from the Sb2O3, while this interfacial reaction is completely absent for Au contacts. Wafer‐scale deposition of high‐κ gate dielectrics compatible with atomically thin van der Waals layered semiconductors (e.g., MoS2, WS2, WSe2) is urgently needed for practical applications of field effect transistors based on 2D materials. A study on a high‐κ molecular crystal antimony trioxide (Sb2O3) gate dielectric examined the role of electrode material on dielectric degradation and breakdown. It is demonstrated that the thin films of Sb2O3 can be uniformly deposited on a wafer scale. The current–voltage (I–V) curves show tightly controlled distributions of both leakage current and breakdown voltage. Electrical measurements reveal that defects are generated gradually upon electrical stressing. The evaluation of degradation is based on charge trapping, stress‐induced leakage current, and dielectric breakdown measurements. The breakdown voltage distribution follows a tight monomodal Weibull distribution suggesting a high quality of the film. Comparing Ti and Au as gate electrodes, both the breakdown field and the tunnel current are affected by the choice of electrode material. Transmission electron microscopy reveals that the chemistry at the electrode/Sb2O3 interface plays an important role and that Ti scavenges oxygen from the Sb2O3, forming a defective oxide layer at the Ti/Sb2O3 interface. For the Au electrode, this interfacial reaction is completely absent, improving the dielectric performance.

A wafer-scale van der Waals dielectric made from an inorganic molecular crystal film

A van der Waals pn heterojunction with organic/inorganic semiconductors

Single-crystalline van der Waals layered dielectric with high dielectric constant

Wafer-scale high-κ dielectrics for two-dimensional circuits via van der Waals integration

Scalable Integration of Hybrid High-Κ Dielectric Materials on Two-Dimensional Semiconductors

A Single‐Crystal Antimony Trioxide Dielectric for 2D Field‐Effect Transistors

Conformal hexagonal-boron nitride dielectric interface for tungsten diselenide devices with improved mobility and thermal dissipation

Few-Layered MnAl2S4 Dielectrics for High-Performance van der Waals Stacked Transistors

Electrodes for High‐κ Molecular Crystal Antimony Trioxide Gate Dielectrics for 2D Electronics

Vertically grown ultrathin Bi 2 SiO 5 as high- κ single-crystalline gate dielectric

Ultrathin Van Der Waals Lanthanum Oxychloride Dielectric for 2D Field-Effect Transistors

A native oxide high-kappa gate dielectric for two-dimensional electronics

Highly reproducible van der Waals integration of two-dimensional electronics on the wafer scale

Ultrathin Van Der Waals Lanthanum Oxychloride Dielectric for Two‐Dimensional Field‐Effect Transistors

Uniform and ultrathin high-κ gate dielectrics for two-dimensional electronic devices

Two-dimensional quasi-freestanding molecular crystals for high-performance organic field-effect transistors

A Single-Crystalline Native Dielectric for Two-Dimensional Semiconductors with an Equivalent Oxide Thickness below 0.5 Nm

Atomic layer deposited 2D MoS2 atomic crystals: from material to circuit

Van der Waals integration of high-κ perovskite oxides and two-dimensional semiconductors

Integrating high-quality dielectrics with one-nanometer equivalent oxide thickness on two-dimensional electronic devices

Epitaxy of Wafer-Scale Single-Crystal MoS2 Monolayer Via Buffer Layer Control