Abstract:During the cold drawing process, pearlite lamellae turn to the drawing direction to form ferrite fiber texture; the cementite lamellae are divided into a multilayer structure, and the dissolution of cementite lamellae in some regions results in the lattice expansion of ferrite phase and the occurrence of neck‐down regions in the cementite lamellae. The microstructure, texture, and dislocation configuration of cold‐drawn pearlitic steel wires were investigated by scanning electron microscopy (SEM), electron backscattering diffraction (EBSD), and transmission electron microscopy (TEM). In addition, Fe/Fe3C interface structure at the atomic level was clearly observed and analyzed by high‐resolution TEM (HRTEM), and the microscopic deformation mechanism of cementite lamellae at different drawing strains is revealed. The results show that pearlite lamellae turn to the drawing direction to form ferrite fiber texture, and the cementite and ferrite lamellae are simultaneously thinned with the increase of drawing strain. During the cold drawing process, shear‐bands(S‐bands) are formed in the cementite lamellae; the dislocation of ferrite transits from single slip to multi‐slip stage, and the dislocation density increases. After drawing, the lattice structures of cementite and ferrite phases show the evolution from single‐crystal to polycrystal, and the cementite lamellae are divided into a multilayer structure: central relative large‐size cementite crystal and outside relative small‐size cementite crystal layer; the dissolution of cementite lamellae in some regions results in the lattice expansion of ferrite phase and the occurrence of neck‐down regions in the cementite lamellae.

Microstructure of Cold Rolled Single Crystal Cu

Effect of cryogenic impact deformation and subsequent annealing on microstructure and microhardness of pure copper

SEM/EBSD Analysis of Changes in Crystal Orientation of {111}〈112〉 Cu Single Crystal Caused by The Cold-Rolling

Microstructure Refinement Mechanism of Undercooled Cu55Ni45 Alloys

Microstructure and Texture Evolution of Cu-Ni-P Alloy after Cold Rolling and Annealing

MICROSTRUCTURAL EVOLUTION OF COLUMNAR GRAIN Al DURING COLD ROLLING II. Mircoscopic Subdivision

Deformation And Annealing Textures Of Extruded And Cold Rolled Pure Ni Single Crystals Of Cube Orientation

Microstructure and Properties of Cold Drawing Cu-2.5% Fe-0.2% Cr and Cu-6% Fe Alloys

Microstructural Evolution of IF-steel During Cold Rolling

Effect of cryogenic rolling on the microstructure and texture of CuCrZr alloy

High Strength and High Electrical Conductivity CuMg Alloy Prepared by Cryorolling

Microstructure and Texture Evolution in Cold-Rolled and Annealed Oxygen-Free Copper Sheets

Microstructural evolution and strengthening mechanisms in cold-rolled Cu–Ag alloys

Investigation on Grain Size Effect of Rolling Texture in Copper

In-situ observations of static recrystallization and texture formation in a cold-rolled CoCrFeMnNi high entropy alloy

Effects of Cold Rolling Reduction Rate on the Microstructure and Properties of Cu-1.16Ni-0.36Cr Alloy after Thermo-Mechanical Treatment

Work Hardening Behavior and Microstructure Evolution of a Cu-Ti-Cr-Mg Alloy during Room Temperature and Cryogenic Rolling

In-situ electron backscatter diffraction of thermal cycling in a single grain Cu/Sn-3Ag-0.5Cu/Cu solder joint

Investigation of Macroscopic Grain Sub-Division of an IF-Steel During Cold-Rolling

Heterogeneous Structure Controlled by Shear Bands in Partially Recrystallized Nano-Laminated Copper

Evolution of Microstructure and Fe/Fe3C Interface Structure in Cold‐Drawn Pearlitic Steel Wires