Abstract:A new way on the magnitude and position of direction change of shear deformation resulted from rolling geometry and friction described by two parameters of Rf and Rp changed with practical rolling conditions is established for analyzing rolling textures. It is found that {001} <110> shear texture is dependent on the parameters of Rf and Rp, and rolling neutral angle is at the middle point of rolling deformation zone, i.e. Rp = 0.5, which favors development of {001}<110> shear texture. The results show that the rolling textures simulated by taking into account of Rf and Rp changed with practical rolling conditions are in better agreement with the measured than that of Rp = 0.5 in rolled high purity Al. Introduction Rolling textures and deformation microstructures have been demonstrated to be changed with rolling geometry and friction on contact surfaces between rollers and sample in previous investigations [1, 2, 3], in which {001}<110> shear texture and micro-shear bands with Cube orientation were found in rolled high purity aluminum with heavier rolling friction. However, the presented ways on effect of rolling geometry and friction on rolling texture components were either simple or complex, and rolling neutral angle position was hypothesized to be at the middle point of rolling deformation zone (RDZ) in literatures [4, 5, 6]. In current investigation, shear deformation can conventionally be changed with practical rolling conditions including rolling geometry and friction, especially, the position of direction change of shear deformation, i.e., rolling neutral angle, is not hypothesized to be at the middle point of RDZ per pass. Development of rolling textures in high purity Al rolled up to different total engineering strains is studied by experiment and modeling. Application of practical conditions on rolling texture modeling Practical Rolling conditions. All that rolling conditions are constrained by three angles, α, β and γ, and a relationship of the three angles can be described as known as

Investigation on Grain Size Effect of Rolling Texture in Copper

Effect of cryogenic impact deformation and subsequent annealing on microstructure and microhardness of pure copper

An Investigation on Rolling Texture Transition in Copper Preprocessed by Equal Channel Angular Pressing

Influence of Cold Rolling Routes on Mechanical Properties of Copper Subjected to ECAP

Microstructure, texture and mechanical properties of pure copper processed by ECAP and subsequent cold rolling

Effect of cryogenic rolling on the microstructure and texture of CuCrZr alloy

Effects of microstructure and texture on the deep drawability of C10200 copper sheets

Texture and Deformation Structure Evolution During Rolling of Individual Grains of Columnar Grain Nickel

The role of Goss-oriented texture for brass-type texture in nickel-based metals during cold rolling

Microstructure and Texture Evolution in Cold-Rolled and Annealed Oxygen-Free Copper Sheets

Mechanical Properties and Microstructure of Rolled and Electrodeposited Thin Copper Foil

The effect of grain size on texture evolution and mechanical properties of an AZ31 magnesium alloy during cold-rolling process

Microstructure, Texture, and Deep Drawability under Two Different Cold-Rolling Processes in Ferritic Stainless Steel

Achieving ultra-fine grains and high corrosion resistance of Al-Zn-Mg-Cu alloy by ECAP and post cold rolling

Crystal Plasticity Finite Element Simulation of Grain Evolution Behavior in Aluminum Alloy Rolling

Effects of Different Modes of Hot Cross-Rolling in 7010 Aluminum Alloy: Part I. Evolution of Microstructure and Texture

Effect of Direction Change of Shear Deformation on the Textures in Rolled High Purity Al

Microstructure, texture evolution and mechanical anisotropy of Mg-Gd-Y-Zn-Zr alloy sheets produced by unidirectional and cross rolling

Effect of the size and dispersion of precipitates formed in hot rolling on recrystallization texture in ferritic stainless steels

Recrystallization and texture evolution during hot rolling of copper, studied by a multiscale model combining crystal plasticity and vertex models

Crystal Plasticity Finite Element Simulation Study on Thread Rolling Pure Aluminum