Abstract:Cu-Fe alloys are expected to be extensively used in electronics, transportation and machinery industries due to the extraordinary mechanical properties and functional properties. To optimize rolling process and the final properties of Cu-Fe plates. The effect of rolling path, rolling temperature and thickness reduction on microstructure evolution, mechanical and electrical properties of Cu-Fe alloy are carefully investigated. The results shown that the thickness reduction has a significant effect on mechanical properties of Cu-Fe alloy. The yield strength of Cu-Fe plates with 20% thickness reduction is more than 2 times higher than that of homogenized ingot. While the yield strength increases gradually as further increasing the thickness reduction. Rolling temperature is an important parameter determining the strength-ductility balance. The strength of plate rolled with 80% thickness reduction at 400 °C is similar to that of the plates in cold-rolled state, and the ductility is higher than that for the plates in the cold-rolled state. Further investigation reveals that the formation of heterogeneous structure characterized with recrystallized-fine grains embedded in deformed-coarse grains is responsible for the observed extraordinary mechanical properties. Rolling path could also affect the microstructure evolution and formability of the plates. For plate rolled with route 1 (unidirectional rolling), a stronger Copper-type texture with two Brass-type textures are observed. For plate rolled with route 2, where the rolled plate is rotated to 90° with respect to previous rolling direction between adjacent rolling passes, only Brass-type texture is generated. A rolling-path dependent edge-crack behavior is observed during rolling. Edge cracks are generated during rolling with route 2, while the edge cracks are not observed for plates rolled with route 1. Factors affecting the edge-cracks behavior are also discussed.

Influence of Cold Rolling Routes on Mechanical Properties of Copper Subjected to ECAP

An Investigation on Rolling Texture Transition in Copper Preprocessed by Equal Channel Angular Pressing

Microstructure, texture and mechanical properties of pure copper processed by ECAP and subsequent cold rolling

Investigation on Grain Size Effect of Rolling Texture in Copper

High strength high conductivity copper prepared by C-ECAP and Cryo-rolling

Effect of Cold Rolling on as–ECAP Interstitial Free Steel

Experimental and Numerical Investigation of the ECAP Processed Copper: Microstructural Evolution, Crystallographic Texture and Hardness Homogeneity

Achieving ultra-fine grains and high corrosion resistance of Al-Zn-Mg-Cu alloy by ECAP and post cold rolling

Tailoring the microstructure and mechanical properties of Cu-Fe alloy by varying the rolling path and rolling temperature

Effect of grain refinement on mechanical and electrochemical properties of severely deformed pure copper through equal channel angular pressing

Mechanical Properties and Microstructure of Rolled and Electrodeposited Thin Copper Foil

Microstructure and Texture Evolution in Cold-Rolled and Annealed Oxygen-Free Copper Sheets

EFFECT OF DIFFERENT STRAIN ROUTES ON MECHANICAL PROPERTIES AND MICROSTRUCTURE OF COPPER

Effect of Single-Pass Rolling on Microstructure and Mechanical Properties of AZ31 Alloy Processed by Equal Channel Angular Pressing

Effect of cryogenic rolling on the microstructure and texture of CuCrZr alloy

Hardness and Texture of Electrolytic Copper Processed by ECAP at Ambient and Warm Temperature

Effect of cryo-rolling on mechanical properties and microstructure of pure copper

Effect of Processing Route on Microstructure and Mechanical Properties in Single-Roll Angular-Rolling

Deformation Microstructure and Property Control of CuCrZr Alloy Directionally Solidified at Room Temperature C-ECAP

Mechanical responses, texture and microstructural evolution of high purity aluminum deformed by equal channel angular pressing

Effects of microstructure and texture on the deep drawability of C10200 copper sheets