Abstract:Asymmetric rolling is beneficial for grain refinement and properties improvement through mass production of metals. This study introduces a novel asymmetric rolling technology, known as dynamic offsets and shear force adjustment (DS) rolling. DS rolling not only achieves roll offset and differential speed/diameter, but maintains a constant offset angle in multiple passes. And rolling mechanics model, finite element model, and rolling experiment is established. The results indicate the advantages of DS rolling in reducing the vertical rolling force with increasing offset angles. Moreover, it is observed that the vertical rolling force initially decreases and subsequently increases as the roll-to-diameter ratio increases. DS rolling enhances both average strain and core strain compared to symmetrical rolling, consequently promoting uniformity in strain distribution and permeability into the core region. The shear stress is the primary factor contributing to the increase in equivalent strain during DS rolling. The adjustment of roller diameter ratio and offset angle allows for control over the shear stress level. DS rolling enhances mechanical properties and refines the grain structure. Notably, at an offset angle of 9°, DS rolling results in a substantial increase in microhardness on the upper surface, center, and lower surface of Cu by 3.31 %, 8.40 %, and 8.19 %, respectively, when compared to symmetrical rolling. Furthermore, DS rolling exhibits an enhanced tensile strength and elongation, yielding improvements of 5.12 % and 38.9 % compared to symmetrical rolling, respectively. Additionally, DS rolling leads to a reduction in grain size by 5.77 %, 17.3 %, and 21.7 % on the upper surface, center, and lower surface, respectively.

Effect of cryo-rolling on mechanical properties and microstructure of pure copper

Effect of cryogenic impact deformation and subsequent annealing on microstructure and microhardness of pure copper

High strength high conductivity copper prepared by C-ECAP and Cryo-rolling

Mechanical Properties of Rolled Copper Foils in Cryogenic and Room‐Temperature Environments

Effect of cryogenic rolling and multistage thermo-mechanical treatment on the microstructure and properties of the Cu-0.4Cr-0.39Zn-0.1Mg-0.07Zr alloy

Effect of cryogenic rolling on the microstructure and texture of CuCrZr alloy

Influence of cold rolling process on microstructure and mechanical properties of Cu-1.5%Ti alloy

Improvement in Strength and Ductility of Asymmetric-Cryorolled Copper Sheets Under Low-Temperature Annealing

Effect of Deep-Cooling Rolling Deformation on the Microstructure and Mechanical Properties of an Al-4.5Cu-1.5Mg-0.6Mn-0.2Ti Alloy

Microstructure, texture and mechanical properties of pure copper processed by ECAP and subsequent cold rolling

Cryorolling impacts on microstructure and mechanical properties of AISI 316 LN austenitic stainless steel

Mechanical Properties and Microstructure of Rolled and Electrodeposited Thin Copper Foil

Work Hardening Behavior and Microstructure Evolution of a Cu-Ti-Cr-Mg Alloy during Room Temperature and Cryogenic Rolling

The mechanical properties of OFHC copper and CuCrZr alloys after asymmetric rolling at ambient and cryogenic temperatures

Influence of Cold Rolling Routes on Mechanical Properties of Copper Subjected to ECAP

Effect of Change in Strain Path During Cold Rolling on the Evolution of Microstructure, Texture And Hardness Properties of Nickel With Extremely Coarse Initial Grain Size

Effects of Cold Rolling Reduction Rate on the Microstructure and Properties of Cu-1.16Ni-0.36Cr Alloy after Thermo-Mechanical Treatment

Mechanical property enhancement and microstructure evolution of an Al-Cu-Li alloy via rolling at different temperatures

Study of mechanical characteristics and strengthening mechanism of AA5154 during cryogenic rolling

Effect of Cold Rolling on the Microstructure and Mechanical Behaviors of High-Nitrogen and Low-Nickel Alloy

Microstructure and mechanical properties of pure copper plate processed by novel dynamic offsets and shear force adjustment rolling