Abstract:In this study, the crystal plasticity finite element method was established by coupling the crystal plasticity and finite element method (FEM). The effect of rolling deformation and slip system of polycrystalline Al-Mg-Si aluminum alloy was investigated. The results showed that there was a pronounced heterogeneity in the stress and strain distribution of the material during cold rolling. The maximum strain and shear strain occurred at surface of the material. The smaller the grain size, the lower the strain concentration at the grain boundary. Meanwhile, a smaller strain difference existed between the grain interior and near the boundary. The rotation of grains leads to significant differences in deformation and rotation depending on their initial orientations during the rolling process. The slip system of (11-1)<-110> had a large effect on the plastic deformation, (111)<10-1> is second, and the effect of (1-11)<011> slip system on the plastic deformation is the smallest. After deformation, the grain orientation concentration was increased with deformation. Therefore, both the strength and volume fraction of texture were increased with the increase in rolling deformation. The experimental results of EBSD indicated that the large rolling reduction resulted in severe grain twisting, so the texture strength was increased. The simulation results were in close agreement with the experimental results. This study provides a theoretical basis for the rolling process, microstructure, and performance control of aluminum alloys.

Crystal Plasticity Finite Element Simulation Study on Thread Rolling Pure Aluminum

Crystal Plasticity Finite Element Simulation of Grain Evolution Behavior in Aluminum Alloy Rolling

Crystal Plasticity Modeling of Texture Evolution and Heterogeneity in Equal Channel Angular Pressing of Aluminum Single Crystal

Influence of Cold Rolling Reduction on the Deformation Behaviour and Crystallographic Orientation Development

An innovation in finite element simulation via crystal plasticity assessment of grain morphology effect on sheet metal formability

Finite Element Simulation of Influences of Grain Interaction on Rolling Textures of Fcc Metals

Investigation on Plastic Flow Behaviors of FCC Polycrystalline Aluminum under Pre-Cyclic Tension-Compression Loading: Experiments and Crystal Plasticity Modeling.

Crystal Plasticity Investigation of Texture Evolution of Al Single Crystal During Extrusion Through a Bent Channel

Crystal Plasticity Investigation of Friction Effect on Texture Evolution of Al Single Crystal During ECAP

Experiments and Crystal Plasticity Finite Element Simulations of Texture Development during Cold Rolling in a Ti-15V-3Cr-3Sn-3Al Alloy

Simulation of Strain Induced Abnormal Grain Growth in Aluminum Alloy by Coupling Crystal Plasticity and Phase Field Methods

Microstructural Evolution and Mechanical Properties of Pure Aluminum upon Multi-Pass Caliber Rolling

Crystal cracking of grain-gradient aluminum by a combined CPFEM-CZM method

A crystal plasticity FEM study of through-thickness deformation and texture in a {112} <111> aluminium single crystal during accumulative roll-bonding

Simulated Microstructure Effects on Macroscopic Mechanical Properties Based on Multiscale Crystal Plasticity

Evolution of Micro-Textures Within Individual Grains in Rolled Polycrystal Aluminum

Numerical Simulation on Sheet Metal Forming with Rate-Independent Polycrystalline Plasticity Fem

In-situ EBSD Study of the Active Slip Systems and Lattice Rotation Behavior of Surface Grains in Aluminum Alloy During Tensile Deformation

Numerical and Experimental Analysis of Deformation Behaviors and Microstructure Evolution in the Thread Rolling Process

Crystal Plasticity Finite-Element Simulation of Ti-6Al-4V Alloy with 3D Polycrystalline Models

Influence of Grain Orientation and Grain Boundary Features on Local Stress State of Cu-8Al-11Mn Alloy Investigated Using Crystal Plasticity Finite Element Method