Abstract:Magnesium and its alloys are characterized by a strong basal texture, resulting in severe anisotropy at low temperature. To investigate the deformation behavior of a rolled magnesium alloy AZ31 at room temperature, uniaxial compression and tension experiments along four directions were performed and modeled using both the EVPSC-TDT and the VPSC-TDT models. The required threshold stress parameters were determined by curve fitting. Similar parameters were found to fit relatively well for all the experimental flow curves for both models. The predictions of the two models are also very similar beyond the elastic strain. The simulations reveal only a very limited increase with strain of the threshold stress for basal slip, which is favorable for basal texture development, whereas the threshold stresses for other deformation modes increase significantly. A discrepancy between experiments and simulations suggests that depending on loading condition strain accommodation between grains by basal slip varies in ease. A deformation-path dependent discrepancy between the modeled stress and the experimental curves is also found for the threshold stress for {10−12} twinning. This discrepancy is assumed to be related to the larger number of twin variants activated in tension as compared to compression, due to twin boundary hardening. A {10−12} twin-associated hardening, primarily on pyramidal slip and prismatic slip systems, evaluated to be about 15MPa for both through thickness tension and in-plane compression, is included in the model via the use of a higher latent hardening modulus these slip systems by twinning.

Multiscale Mechanical Behavior and Microstructure Evolution of Extruded Magnesium Alloy Sheets: Experimental and Crystal Plasticity Analysis

Constitutive Modeling of Slip, Twinning and Detwinning for Mg Alloy and Inhomogeneous Evolution of Microstructure

In-situ Analysis of Microscopic Plastic and Failure Behaviors of Extruded Magnesium Alloy

Numerical simulation of plastic behavior and meso inhomogeneous deformation in AZ31 Mg alloy

Simulation of the Extrusion Texture of Magnesium Alloy AZ31 Using Crystal Plasticity Finite Element Method

Characterizing microscale deformation mechanisms and macroscopic tensile properties of a high strength magnesium rare-earth alloy: A combined experimental and crystal plasticity approach

Crystal plasticity based modeling of grain boundary sliding in magnesium alloy AZ31B sheet

Polycrystal plasticity simulation of extrusion of a magnesium alloy round bar: Effect of strain path non-uniformity

Crystal Plasticity Finite Element Modelling of the Extrusion Texture of A Magnesium Alloy

Simulation of Magnesium Alloy AZ31 Sheet During Cylindrical Cup Drawing with Rate Independent Crystal Plasticity Finite Element Method

Polycrystalline Behavior Analysis of Extruded Magnesium Alloy AZ31

The Polycrystalline Plasticity Due to Slip and Twinning During Magnesium Alloy Forming

Deformation Analysis of Magnesium Alloy Based on Crystal Plasticity Theory

An Elastic–viscoplastic Crystal Plasticity Modeling and Strain Hardening for Plane Strain Deformation of Pure Magnesium

Crystal Plasticity Simulation of the AZ31B Alloy Sheet under Uniaxial Deformation Considering Grain Boundary Sliding

Modeling the Deformation Behavior of A Rolled Mg Alloy with the Evpsc-Tdt Model

A Cyclic Stress-Strain Constitutive Model for Polycrystalline Magnesium Alloy and Its Application

Crystal Plasticity Analysis of Plane Strain Deformation Behavior and Texture Evolution for Pure Magnesium

Grain size and orientation affected deformation inhomogeneity and local damage of hot-deformed Al-Zn-Mg alloy

Research Advances in Multi-Scale Numerical Simulations of Forming and Microstructures for Magnesium Alloys