Abstract:To lower the bonding temperature and save the time of the Cu-Cu bonding applied for 3D integration, Ag nanostructure was deposited on the Cu pads as intermediate by femtosecond pulsed laser deposition (PLD). The interface morphology after bonding including oxidation detection and microstructure evolution during high-temperature storage was investigated. The underlying bonding mechanisms were then analyzed and concluded. The element distribution of Ag nanostructures after PLD deposition is detected using the scanning transmission electron microscope equipped with energy dispersive X-ray spectroscopy mapping, and no oxygen is found inside the nanostructures. The electron energy loss spectroscopy shows that no oxidation happens across the Cu-Ag-Cu bonding interfaces during the bonding process by observing the same chemical state of Ag and Cu as the pure metal atom. The as-bonded Cu-Ag-Cu samples were stored at the temperature of 200 degrees C for 500 h and the microstructure at the bonding interface was observed. Based on the interface microstructure and crystal structure, the physical mechanisms of Cu-Cu bonding using Ag nanostructure as intermediate was explored and summarized in detail. The mechanical interlock between Ag nanostructures, large plastic deformation, surface melting and bulk diffusion are found to simultaneously contribute to the bonding. (C) 2018 Elsevier B.V. All rights reserved.

Nano-Cu Paste Sintering in Pt-catalyzed Formic Acid Vapor for Cu Bonding at a Low Temperature

Sintering of Mixed CuAg Nanoparticles Pretreated by Formic Acid Vapor for CuCu Low Temperature Bonding

Low temperature Cu bonding with large tolerance of surface oxidation

Low Temperature Bonding Process Using Mixed Cu-Ag Nanoparticles for Electronic Packaging

Low Temperature Bonding of Cu Metal through Sintering of AgNanoparticles for High Temperature Electronic Application

Cu-Cu joining using citrate coated ultra-small nano-silver pastes

Low Temperature Fine-pitch Cu-Cu Bonding Using Au Nanoparticles As Intermediate

Low Temperature Cu-Cu Bonding Using Ag Nanoparticles By Pvd

Bonding of Cu to Cu bulks through the low temperature sintering of Ag nanoparticle paste

Low Temperature Cu-Cu Bonding Using Copper Nanoparticles Fabricated by High Pressure Pvd

Mechanism of Low Temperature Sintering-Bonding Through In-Situ Formation of Silver Nanoparticles Using Silver Oxide Microparticles

Low-Temperature Cu-Cu Bonding Using Silver Nanoparticles Fabricated by Physical Vapor Deposition

Low Temperature Bonding of Metals by Deposition of Nanoparticles at the Interface

Cu-Cu joint formation by low-temperature sintering of self-reducible Cu nanoparticle paste under ambient condition

Anti-oxidative Copper Nanoparticle Paste for Cu–Cu Bonding at Low Temperature in Air

A Novel Cu@Ag Nano Paste with Low Porosity for Rapidly Sintering in Air Condition

Large-area and Low-Cost Cu–Cu Bonding with Cold Spray Deposition, Oxidation, and Reduction Processes under Low-Temperature Conditions

Enhanced shear strength and microstructure of Cu–Cu interconnection by low-temperature sintering of Cu nanoparticles

Thermal-stable Void-Free Interface Morphology and Bonding Mechanism of Low-Temperature Cu-Cu Bonding Using Ag Nanostructure As Intermediate

A Study on the Low Temperature Sintering-Bonding Through In-Situ Formation of Ag Nanoparticles Using Ag2o Microparticles

The Low Temperature Exothermic Sintering of Formic Acid Treated Cu Nanoparticles for Conductive Ink