Abstract:To lower the Cu-Cu bonding temperature and save the time of the bonding process applied for 3D integration, the Ag nanostructure deposited by pulsed laser deposition (PLD) was designed and decorated on the Cu pads as intermediate. Influences of different PLD process parameters on the designed Ag nanostructure morphology were investigated in this work. The large nanoparticles (NP) defects, NPs coverage rate on the Cu pad, and NPs size distribution were adopted to evaluate the PLD parameters based on the NPs morphology observation and the Cu-Cu bonding quality. The medium laser power of 0.8 W, smaller distance between target and substrate, and protective container should be applied in the optimized PLD to obtain the Ag nanostructure. Then a loose 3D mesh Ag nanostructure consisted of the protrusions and grooves was formed and the morphology observation proved the nanostructure deposition mechanism was contributed to the block of nano-film nucleation and nanoparticles absorption. Finally, the relationship between the bonding temperature and pressure suitable for the Ag nanostructure had been determined based on shear strength and interface observation. The results revealed the combination of higher bonding temperature (250 degrees C) and lower pressure (20 MPa), or lower bonding temperature (180 degrees C) and higher pressure (50 MPa) can both achieve the bonding process with the short bonding time of 5 min and annealing at 200 degrees C for 25 min in vacuum furnace. (C) 2018 Elsevier B.V. All rights reserved.

Low Temperature Cu-Cu Bonding Using Ag Nanoparticles By Pvd

Low-Temperature Cu-Cu Bonding Using Silver Nanoparticles Fabricated by Physical Vapor Deposition

Low Temperature Cu-Cu Bonding Using Copper Nanoparticles Fabricated by High Pressure Pvd

Low Temperature Cu-Cu Bonding Using Ag Nanostructure for 3d Integration

Cu-Cu Bonding By Ag Nanostructure At Low Temperature Of 180 Degrees C

Cu-Cu bonding by Ag nanostructure at low temperature of 180 °C

Low Temperature Fine-pitch Cu-Cu Bonding Using Au Nanoparticles As Intermediate

Low Temperature Fine-Pitch Wafer-Level Cu-Cu Bonding Using Nanoparticles Fabricated by PVD

Sintering of Mixed CuAg Nanoparticles Pretreated by Formic Acid Vapor for CuCu Low Temperature Bonding

Thermal-stable Void-Free Interface Morphology and Bonding Mechanism of Low-Temperature Cu-Cu Bonding Using Ag Nanostructure As Intermediate

Polymer-Protected Cu-Ag Mixed NPs for Low-Temperature Bonding Application

Low Temperature Bonding Process Using Mixed Cu-Ag Nanoparticles for Electronic Packaging

Low Temperature Bonding of Cu Metal through Sintering of AgNanoparticles for High Temperature Electronic Application

Preparation of PVP Coated Cu NPs and the Application for Low-Temperature Bonding

Characterization of low temperature bonding with Cu nanoparticles for electronic packaging application

Low temperature Cu bonding with large tolerance of surface oxidation

Low-temperature Cu Cu Direct Bonding with Ultra-Large Grains Using Highly (110)-Oriented Nanotwinned Copper

Bonding of Cu to Cu bulks through the low temperature sintering of Ag nanoparticle paste

Modified Pulse Laser Deposition of Ag Nanostructure As Intermediate for Low Temperature Cu-Cu Bonding

Low Temperature Cu-Cu Bonding Using an Intermediate Sacrificial Sn Layer

Low Temperature Cu/SiO2 Hybrid Bonding with Protruding Copper Pads