Abstract:In order to lower Cu-Cu bonding temperature and shorten bonding time applied for 3D integration, nanostructure has been introduced on bonding Cu surface. However, few studies have been reported on Nano Particles (NPs) formation by film deposition process such as pulsed laser deposition (PLD), which would be compatible with CMOS process. In this work Ag nanostructure containing strings of NPs was formed by optimized PLD process, which is mostly used for nanofilm deposition. Then NPs morphology was observed by scanning electron microscope (SEM) and transmission electron microscopy (TEM). Ag nanostructure was consisted of strings of loose mesh structures filled with NPs with size range from several milometers to tens of nanometcrs. They were compressible and of high movability, which was significantly benefit for lowering bonding temperature. With these Ag nanostructure on Cu pads, chips were pre-bonding at the low temperature of 180 degrees C for 5 min and afterwards all the chips were simultaneously annealed at the temperature of 200 degrees C for 25 min. After die shear test, average shear strength of 15.8 MPa was obtained and fracture surface was inspected by SEM. After TEM observation of bonding interface, continuous Cu-Ag-Cu interfaces with almost no void were observed. It confirmed low temperature Cu-Cu bonding with Ag nanostructure by PLD was a reliable and time-saving process, which might be a promising technology for 3D integration.

Preparation of PVP Coated Cu NPs and the Application for Low-Temperature Bonding

Low Temperature Cu-Cu Bonding Using Copper Nanoparticles Fabricated by High Pressure Pvd

Polymer-Protected Cu-Ag Mixed NPs for Low-Temperature Bonding Application

Low-Temperature Cu-Cu Bonding Using Silver Nanoparticles Fabricated by Physical Vapor Deposition

Low Temperature Fine-Pitch Wafer-Level Cu-Cu Bonding Using Nanoparticles Fabricated by PVD

Low Temperature Cu-Cu Bonding Using Ag Nanoparticles By Pvd

Characterization of low temperature bonding with Cu nanoparticles for electronic packaging application

Low Temperature Fine-pitch Cu-Cu Bonding Using Au Nanoparticles As Intermediate

Effect of Pvp on the Low Temperature Bonding Process Using Polyol Prepared Ag Nanoparticle Paste for Electronic Packaging Application

Low Temperature Bonding of Cu Metal through Sintering of AgNanoparticles for High Temperature Electronic Application

Low temperature Cu bonding with large tolerance of surface oxidation

Low Temperature Bonding Process Using Mixed Cu-Ag Nanoparticles for Electronic Packaging

Rapid and Low Temperature Sintering Bonding Using Cu Nanoparticle Film for Power Electronic Packaging

A mild aqueous synthesis of ligand-free copper nanoparticles for low temperature sintering nanopastes with nickel salt assistance

Cu-Cu Bonding By Ag Nanostructure At Low Temperature Of 180 Degrees C

Nano-Cu Paste Sintering in Pt-catalyzed Formic Acid Vapor for Cu Bonding at a Low Temperature

Low-temperature Cu Cu Direct Bonding with Ultra-Large Grains Using Highly (110)-Oriented Nanotwinned Copper

Anti-oxidative Copper Nanoparticle Paste for Cu–Cu Bonding at Low Temperature in Air

Low Temperature Bonding of Metals by Deposition of Nanoparticles at the Interface

Cu-Cu bonding by Ag nanostructure at low temperature of 180 °C