Abstract:In this experiment, silver nanoparticles (AgNPs) were prepared by the polyol method, which is simple and low-cost. The AgNPs were characterized by SEM, UV–Vis, and XRD. It was determined that the prepared AgNPs had good morphology and the average particle size was about 53.01 nm. At the same time, the optimum conditions for preparation were determined: The molar ratio of polyvinylpyrrolidone K30 (PVP K-30) to AgNO 3 was 6:1, the reaction time was 40 min, and the reaction temperature was 160 °C. Then the sintering process parameters were discussed. It was determined that when the content of AgNPs was 2.5%, the temperature of high-temperature sintering should reach 250 °C and above, the time should reach 30 min and above, and the lowest resistivity reaches 0.7 × 10 −5 Ω·m under high-temperature sintering. In chemical sintering, Cl − replaces the N and O atoms of PVP K-30, induces spontaneous aggregation of Ag, and completes room temperature sintering. It is found that the sintering time needs to reach 30 min or more, and the resistivity is 3.325 × 10 −5 Ω·m. Finally, the conductive region is printed by the material deposition system and the strain sensor is prepared by two sintering methods. The experimental test proves that the sensor prepared by high-temperature sintering has good cycle response and stability. The sensor prepared by chemical sintering has a good cycle response, but the repeatability is poor, which is not conducive to long-term high-strength use. The sensor can be applied to the field of flexible electronic products.

Effect of Pvp on the Low Temperature Bonding Process Using Polyol Prepared Ag Nanoparticle Paste for Electronic Packaging Application

Large-scale synthesis of Ag nanoparticles by polyol process for low temperature bonding application

Preparation of PVP Coated Cu NPs and the Application for Low-Temperature Bonding

Improvement of Bondability by Depressing the Inhomogeneous Distribution of Nanoparticles in a Sintering Bonding Process with Silver Nanoparticles

Low Temperature Bonding Process Using Mixed Cu-Ag Nanoparticles for Electronic Packaging

Low-Temperature sintering bonding using silver nanoparticle paste for electronics packaging

A Review Of Sintering-Bonding Technology Using Ag Nanoparticles For Electronic Packaging

Polymer-Protected Cu-Ag Mixed NPs for Low-Temperature Bonding Application

Low temperature nanojoining of silver–copper nanopaste as die attach material for high temperature packaging

Low Temperature Sintering-Bonding Through In-Situ Formation of Ag Nanoparticles Using Micro-Scaled Ag_2O Composite Paste

Sintering bonding process with Ag nanoparticle paste and joint properties in high temperature environment

Low Temperature Sintering of Silver Nanoparticle Paste for Electronic Packaging

Pressureless Bonding Process Using Ag Nanoparticle Paste for Flexible Electronics Packaging

A Study on the Low Temperature Sintering-Bonding Through In-Situ Formation of Ag Nanoparticles Using Ag2o Microparticles

Characterization of low temperature bonding with Cu nanoparticles for electronic packaging application

Sintering mechanisms and mechanical properties of joints bonded using silver nanoparticles for electronic packaging applications

Large-Scale synthesis of silver nanoparticles by aqueous reduction for low-temperature sintering bonding

Rapid Fabrication of Joints Using Low Temperature Sintered Silver Nanoparticles

Low Temperature Bonding of Cu Metal through Sintering of AgNanoparticles for High Temperature Electronic Application

Process optimization of simple preparation of AgNPs by polyol method and performance study of a strain sensor

Low Temperature Cu-Cu Bonding Using Ag Nanoparticles By Pvd