Abstract:A synthetic partial discharge (PD) calibrator has been developed to qualify PD analyzers used for insulation diagnosis of HVAC and HVDC grids including cable systems, AIS, GIS, GIL, power transformers, and HVDC converters. PD analyzers that use high-frequency current transformers (HFCT) can be qualified by means of the metrological and diagnosis tests arranged in this calibrator. This synthetic PD calibrator can reproduce PD pulse trains of the same sequence as actual representative defects (cavity, surface, floating potential, corona, SF6 protrusion, SF6 jumping particles, bubbles in oil, etc.) acquired in HV equipment in service or by means of measurements made in HV laboratory test cells. The diagnostic capabilities and PD measurement errors of the PD analyzers using HFCT sensors can be determined. A new time parameter, "PD Time", associated with any arbitrary PD current pulse i(t) is introduced for calibration purposes. It is defined as the equivalent width of a rectangular PD pulse with the same charge value and amplitude as the actual PD current pulse. The synthetic PD calibrator consists of a pulse generator that operates on a current loop matched to 50 Ω impedance to avoid unwanted reflections. The injected current is measured by a reference measurement system built into the PD calibrator that uses two HFCT sensors to ensure that the current signal is the same at the input and output of the calibration cage where the HFCT of the PD analyzer is being calibrated. Signal reconstruction of the HFCT output signal to achieve the input signal is achieved by applying state variable theory using the transfer impedance of the HFCT sensor in the frequency domain.

A Method for Measurement of Step Voltage Rise Time of Partial Discharge Calibrators

Study on the Calibration of Partial Discharge Calibrators of Charge from 0.1pc to 10Nc

A novel calibration method for PD measurements in power cables and joints using capacitive couplers

Measurement of DC Partial Discharge of High-voltage Storage Capacitor

Investigation and Design of Partial Discharge Calibrator

The Measurement System of Partial Discharge under Impulse Voltage

Measurement and analysis for pulse sequence of partial discharge signals under DC voltage

High Sensitive DCPD Measurement and Analysis System of High-Voltage Storage Capacitor

Development of an Industrial Partial Discharge Calibrator and Its Performance Tests

Study on waveform characteristics of partial discharge pulses in air

Development of the Step Pulse Generator for Calibrating the Very Fast Transient Voltage Measuring System

Measurement and Analysis System for Partial Discharge under Continuous Square Pulse Voltage

The Design of Calibration System Based on Cable Accessories

New Synthetic Partial Discharge Calibrator for Qualification of Partial Discharge Analyzers for Insulation Diagnosis of HVDC and HVAC Grids

Measurement principle of tuned balance method for partial discharge

Comparison Of Partial Discharge Measurement Methods Under The Oscillating Lightning Impulse Voltage In Gis

Pulse Quantitative Determination in Partial Discharge Detection Using Wide Bandwidth Pulse Current Method

Design of Partial Discharge Testing System under Continuous Square Pulse Voltage

On-line Calibration of Partial Discharge Monitoring for Power Cable by HFCT Method

PRINCIPLE OF SELECTIVE FREQUENCY BALANCE METHOD FOR PD MEASURING

Research on Time-Domain Transfer Impedance Measurement Technology for High Frequency Current Transformers in Partial Discharge Detection of Cables