Abstract:A wide-band online partial discharge(PD)detection method is discussed to minimize the influence of the noise and interferences during the course of measurement and diagnosis followed.The traditional IEC pulse current detection method and the recently developed ultra high frequency detection method have limited their bandwidth to avoid the abundant ambient noise and interference,and loss of the information of the PD signals as well.The methods can not record the entire discharge waveforms of the PD current pulses,causing a fundamental lack of information to neither differentiate various signals and noises,nor distinguish various PD or interference patterns.The wide band detection method covers a bandwidth wide enough to record the entire partial discharge pulse waveforms.Based on the features of their pulse waveforms,such signals can be separated and recognized in a'clean'condition.An experiment employing such method on a 110kV cable with several discharge patterns and onsite noises is presented.The analysis shows that,with sufficient information of the entire waveform,those discharge patterns can be separated,and each of the'clean and pure'sub-patterns,such as the internal discharge and background noises can be isolated and well recognized.For field PD detection and diagnosis,the method would increase the ability to remove the impact of onsite noises and interferences,as well as the ability to diagnose the insulation condition based on the PD information.

Pulse Quantitative Determination in Partial Discharge Detection Using Wide Bandwidth Pulse Current Method

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

On-site Application of Partial Discharge Detection of Transformer Using Very Wide Bandwidth Pulse Current Method

Detection and Identification Technologies of Wide Band Partial Discharge

Suppression of Pulse Interference in Partial Discharge Measurement Based on Phase Correlation and Waveform Characteristics

Research on the Calibration Methods for Ultra-high Frequency Partial Discharge Detector

Study on waveform characteristics of partial discharge pulses in air

Wavelet transform applying in partial discharge measurement

Frequency Band of Pulse Current Method for the Measurement of PD in Transformer

Calibration Technology and Application of Ultrasonic Sensor for Partial Discharge Detector

Development of a Wideband TMR Current Sensor for Partial Discharge Monitoring

Study on the Calibration of Partial Discharge Calibrators of Charge from 0.1pc to 10Nc

Development of an Industrial Partial Discharge Calibrator and Its Performance Tests

Study on Pulse Current of Partial Discharge by Using Joint Time-Frequency Analysis Methods

The Design of Calibration System Based on Cable Accessories

A Feasibility Study on Bushing Tap UHF Sensing Method for Partial Discharge in Transformer

Study on pulse current of typical PD models in power transformer

Time-Frequency Analysis on Pulse Current of Partial Discharge by Adaptive Spectrogram

Study on on-line calibration of partial discharge in power transformers

Relationship Between Time-Frequency Representation of PD-induced UHF Signal and PD Current Pulse