Abstract:The measurement of partial discharge (PD) using ultra-high frequency (UHF) method is considered an effective approach to monitor the online condition of the equipment, which is used to facilitate the detection of incipient defects in gas-insulated switchgear (GIS). In this paper, in order to assess the severity of PD defects using UHF method, the actual 220-kV GIS were subjected to experimentation. The PD was measured simultaneously by using the UHF method and the IEC60270 measurement technique. The combined measurement has been carried out on different defects in PD test cells, including the floating metal, metallic protrusion, and void in epoxy resin. The inner coupler installed in the GIS tank, and the outer coupler placed outside the spacer, are used to measure the UHF signal. The relationship of the apparent charge and the amplitude of the time-domain signal, and the integral energy from 300 MHz to 1.6 GHz of the signal induced by PD in GIS are analyzed thoroughly. In this way, the severity of PD can be quantified using the UHF signal. In addition, to verify the sensitivity of the UHF detection method, a pulse generator with a rise time of about 500 ps is designed. The GIGRE method for the verification of sensitivity, which is used worldwide, is applied in the experiment. The results of the pulse generator experiment are compared to the results produced by the actual discharge sources, and several possible approaches of improving this method are proposed.

Research on the Calibration Methods for Ultra-high Frequency Partial Discharge Detector

Calibration Technology and Application of Ultrasonic Sensor for Partial Discharge Detector

The Design of Calibration System Based on Cable Accessories

The Frequency Range Selection for Measurement of Partial Discharge in Transformer Oil with UHF Method and Interference Suppression

Evaluation of the UHF Method Based on the Investigation of a Partial Discharge Case in Post Insulators

Investigation of the Evaluation of the Pd Severity and Verification of the Sensitivity of Partial-Discharge Detection Using the Uhf Method in Gis

Research on the Typical Partial Discharge Using the UHF Detection Method for GIS

Experimental Investigation on High Frequency Sensing Characteristis of Floating Type Partial Discharge

A novel calibration method for PD measurements in power cables and joints using capacitive couplers

Application of HFCT and UHF Sensors in On-Line Partial Discharge Measurements for Insulation Diagnosis of High Voltage Equipment

Study on the Calibration of Partial Discharge Calibrators of Charge from 0.1pc to 10Nc

Investigation on the Sensitivity of the UHF Method for Partial Discharge Detection in GIS

Study on on-line calibration of partial discharge in power transformers

Investigation of the UHF Partial Discharge Detection Characteristics of a Novel Bushing Tap Sensor for Transformers

Pulse Quantitative Determination in Partial Discharge Detection Using Wide Bandwidth Pulse Current Method

Study on Miniaturized UHF Antennas for Partial Discharge Detection in High-Voltage Electrical Equipment

Relationship Between Time-Frequency Representation of PD-induced UHF Signal and PD Current Pulse

Investigation of Sensitivity of the Ultra-High Frequency Partial-Discharge Detection Technology for Micro-Crack in Epoxy Insulator in GIS

A Feasibility Study on Bushing Tap UHF Sensing Method for Partial Discharge in Transformer

Detection and Identification Technologies of Wide Band Partial Discharge

Partial Discharge Wideband Full-Band High-Gain Resonant Cavity UHF Sensor Research