Abstract:Partial discharge (PD) detection is an effective method for finding insulation defects in HV and EHV power cables. PD apparent charge is typically expressed in picocoulombs (pC) when the calibration procedure defined in IEC 60270 is applied during off-line tests. During on-line PD detection, measured signals are usually denoted in mV or dB without transforming the measured signal into a charge quantity. For AC XLPE power cable systems, on-line PD detection is conducted primarily with the use of high frequency current transformer (HFCT). The HFCT is clamped around the cross-bonding link of the joint or the grounding wire of termination. In on-line occasion, PD calibration is impossible from the termination. A novel on-line calibration method using HFCT is introduced in this paper. To eliminate the influence of cross-bonding links, the interrupted cable sheath at the joint was reconnected via the high-pass C-arm connector. The calibration signal was injected into the cable system via inductive coupling through the cable sheath. The distributed transmission line equivalent circuit of the cable was used in consideration of the signal attenuation. Both the conventional terminal calibration method and the proposed on-line calibration method were performed on the coaxial cable model loop for experimental verification. The amplitude and polarity of signals that propagate in the cable sheath and the conductor were evaluated. The results indicate that the proposed method can calibrate the measured signal during power cable on-line PD detection.

A Method to Improve the Efficiency of Onsite Damped AC Test of Medium-voltage Cables

A Cost-Effective Technique for PD Testing of MV Cables under Combined AC and Damped AC Voltage

The implementation of a cost‐efficient damped AC testing methodology for transmission cables based on DC–AC conversion and distributed partial discharge detection

An Improved Design of Damped AC Test System for Partial Discharge Measurement in Distribution Power Cables

Novel dual‐resonance damped alternating current testing system for offline partial discharge measurement of power cables

An Efficient Methodology of Simultaneous Three-Phase Withstand Voltage and Sensitive Partial Discharge Testing of Medium Voltage Power Cables

On-site Partial Discharge Detection of Power Cables Using a Novel DAC Technique Supplied by a Capacitor Bank

A Low-cost DAC System for On-site PD Testing of HV Cables Based on ACRF and Capacitor Bank

Study on the DAC System for 10kv Cable Insulation Testing Based on DC-AC Technology

A Novel DAC Generator for PD Testing of MV Cable Insulation

A Cable Insulation Condition Detection Method Based on H-Bridge Cascading and Resonance

A Method for Constructing Short-Time AC Voltage Generator to Evaluate Cable Conditions

An Improved Variable-Frequency Series Resonant System for PD Detection of MV Power Cables Based on DAC Technology

On-site Insulation Tests for MV Cable Using Very Low Frequency and Damped AC Techniques

Comparative Investigations on XLPE Cables with Using Damped-Ac and 50-Hz-ac

Development of Damped Ac Voltage Generator for the Partial Discharge Detection of Distribution Power Cables

On-line Calibration of Partial Discharge Monitoring for Power Cable by HFCT Method

A Thermal Excitation Based Partial Discharge Detection Method for Cable Accessory

A Novel On-Line Differential Technique For Partial Discharge Measurement Of Mv/Hv Power Cables

An ACRF Technique for PD Detection of XLPE Cables Based on Equivalent Pulse Width Modulation and Time Domain Reflectometry Denoising

Study on Characteristics of Partial Discharge in Xlpe Cable under Damped Ac Voltage at Different Frequencies