Abstract:On-line partial discharge (PD) detection and location has proven to be a valuable tool for assessing the condition of medium-voltage (MV) power cables in service. A few advances are discussed in this paper. It is of importance to know all factors affecting PD activity in order to judge its severity. Cable temperature, more specifically its variation due to load cycling, is one key parameter. From the variation of the signal propagation velocity along the cable it is shown that the temperature can be monitored within one degree centigrade accuracy. The PD activity was found to respond upon temperature cycling caused by load variation. Moreover, data gathered from years of field experience has led to more insight in the predictability of upcoming faults based on (trends in) PD activity. It is possible now to identify the time between the moment partial discharges appear (or reach a certain level) and a final breakdown for different types of cable insulation. Occasionally, cable faults occur without being preceded by PD activity. For distribution network operators, a quick location of a MV cable fault, either a direct complete fault or a self-healing (or intermittent) fault, will contribute to reduce the outages both in duration and frequency. The earlier applied PD location technique is extended to capture also faults based on first arrival of the associated transients. This fault pinpointing is possible for any MV power cable type within 1% of the cable length, independent of the network grounding and whether a fault is a permanent one or a self-healing one. This paper presents the various techniques and results from test cases and a real captured field fault.

The Application of Partial Discharge Detection for the Condition Assessment of Xlpe Power Cables

Radio-frequency Detection of Partial Discharge in Power Cable Joints

Detection Method Of Partial Discharge In Xlpe Cable Accessories Based On The Method Of Vhf Combined With Acoustic Emission

Review on Detection and Analysis of Partial Discharge along Power Cables

A Thermal Excitation Based Partial Discharge Detection Method for Cable Accessory

RESEARCH AND DEVELOPMENT OF ON-LINE MONITORING SYSTEM WITH PARTIAL DISCHARGE IN XLPE POWER CABLES

Distributed Partial Discharge Detection Technology for High Voltage Cable Based on Ac Withstand Voltage

Comparison of on-line partial discharge detection methods for HV cable joints

A Partial Discharge Detection System for XLPE Cable Terminals and Acoustic Wave Sensing Characteristics Based on Fiber Optic Mach-Zehnder Interferometer

Investigation of partial discharge characteristics in XLPE cable insulation under increasing electrical stress

Partial discharge detection on power equipment using a magneto-resistive sensor

Application of Capacitor Sensor in PD Detection at the Three-Phase Cross-Bonding Link-System of XLPE Cable

Detection and Identification Technologies of Wide Band Partial Discharge

Research on Combination of Partial Discharge Inspection of Cable and Accurate Position Detection of Oscillating Wave

Distributed Detection and Acoustic Emission Waveform Retrieval of Cable Joint Partial Discharge

Guarding MV cables on-line: With travelling wave based temperature monitoring, fault location, PD location and PD related remaining life aspects

Partial Discharge Detection and Defect Location Method in GIS Cable Terminal

Dielectric loss and partial discharge test analysis of 10 kV XLPE cable

The Development of Mobile On-line Partial Discharge Monitoring System of XLPE Cable

A novel calibration method for PD measurements in power cables and joints using capacitive couplers

Simulation and Partial Discharge Detection for Typical Defects of 10 Kv Cable the Joint