Abstract:Locating partial discharge in power networks is a challenging but important task. This paper applies electromagnetic time reversal to single‐ended measurements in a network consisting of different cable technologies and a ring main unit. The discharge event is located to within 0.1% accuracy. In online single‐sided partial discharge (PD) location, the measured PD reflection patterns are affected by the characteristics of all the components of the associated power network. This paper analyses the performance of a PD location method based on electromagnetic time reversal (EMTR) theory, when interfering reflections contribute to the transient signals emitted by the PD event. The topology analysed is formed from a ring main unit (RMU) in a medium voltage grid with mixed cross‐linked polyethylene and paper‐insulated lead‐covered (PILC) cable sections. The PD reflection patterns, observed at the RMU, are disturbed by the reflections coming from the impedance discontinuities of the circuit and by the reflections coming from the cable ends of the PILC cables connected to the RMU. The simulated configuration is chosen such that classical location techniques tend to fail due to overlapping peaks and other signal distortion. This is because the classic techniques are based on identifying individual reflection peaks from which the PD source can be determined via differences in time of arrival. The numerical investigation shows that the accuracy of the EMTR‐based location method is robust against these effects, achieving a PD localisation with an error less than the 0.1%. The results also show that the EMTR‐based method can localise PDs using a PD monitoring point located somewhere along the network and not necessarily at the line termination.

Guarding MV cables on-line: With travelling wave based temperature monitoring, fault location, PD location and PD related remaining life aspects

Radio-frequency Detection of Partial Discharge in Power Cable Joints

Load and Other Effects on Measuring Partial Discharge in Power Cables

Signal Processing of On-line Partial Discharge Measurements On HV Power Cables

On-Line Partial Discharge Localization in Power Cables Based on Electromagnetic Time Reversal Theory - Numerical Validation

Application Of The Online Partial Discharge Monitoring For The Ehv Xlpe Cable System

Partial discharge theory and technologies related to medium-voltage electrical equipment

Review on Detection and Analysis of Partial Discharge along Power Cables

An overview on the current status of partial discharge measurements on AC high voltage cable accessories

The Application of Partial Discharge Detection for the Condition Assessment of Xlpe Power Cables

Investigation of partial discharge characteristics in XLPE cable insulation under increasing electrical stress

On-line Calibration of Partial Discharge Monitoring for Power Cable by HFCT Method

On-Line Partial Discharge Localization of 10-Kv Covered Conductor Lines

A Novel On-Line Differential Technique For Partial Discharge Measurement Of Mv/Hv Power Cables

A Review on the Classification of Partial Discharges in Medium-Voltage Cables: Detection, Feature Extraction, Artificial Intelligence-Based Classification, and Optimization Techniques

A High‐efficiency Portable System for Insulation Condition Assessment of Wind Farm Inter‐array Cables with Double‐sided Partial Discharge Detection and Localisation

A Distributed Pd Detection Method for High Voltage Cables Based on High Precision Clock Synchronization

DSP Based On-Line Partial Discharge Monitoring System for High Voltage Power Cable

Distributed Partial Discharge Detection Technology for High Voltage Cable Based on Ac Withstand Voltage

Electromagnetic time reversal for online partial discharge location in power cables: Influence of interfering reflections from grid components

Partial Discharge Characteristics and Mechanism of Medium Voltage Power Cable Defects under Different Voltage Stresses