Abstract:In this paper, we present a broadband out-of-phase power divider with high power-handling capability. The proposed device consists of several sections of double-sided parallel-strip lines (DSPSLs), a mid-inserted conductor plane, and two external isolation resistors, which are directly grounded for heat sinking. A through ground via (TGV), connecting the top and bottom sides of DSPSLs, is employed. The special metal via is realized to short the isolation resistors at full-frequency band when the odd-mode is excited. Meanwhile, it can be ignored as the excitation is even-mode. This property is efficiently utilized to improve the bandwidth. To examine the proposed power divider in detail, a set of closed-form equations are derived. Meanwhile, the power operation analysis illustrates that the proposed power divider is a good candidate for high power applications. The design charts show that the proposed device can support a wide frequency ratio range (1-1.7). Furthermore, broadband responses can be obtained when proper frequency ratios are adopted. For verification, an experimental power divider operating at 1.25/1.75 GHz is implemented. The measured results exhibit a bandwidth of 44.3% with better than 15 dB return loss and 18 dB port isolation is achieved.

Novel Planar Compact Coupled-Line Singleended-To-Balanced Power Divider

A Half-Mode Substrate Integrated Waveguide Ring for Two-Way Power Division of Balanced Circuit

Compact Rat-Race Coupler with Double-Sided Parallel-Strip Line (DSPSL) for Dual-Band Arbitrary Power Divisions

A Compact Gysel Power Divider with Unequal Power-Dividing Ratio Using One Resistor

Miniaturization of Rat-Race Coupler With Dual-Band Arbitrary Power Divisions Based on Stepped-Impedance Double-Sided Parallel-Strip Line

Compact Dual-Band Balanced-to-Unbalanced Filtering Power Divider Design With Extended \textCommon-Mode Suppression Bandwidth

A Design of V-band Reconfigurable SPDT Switch/Power Divider Based on Slotted SIW

Novel Dual-Band Out-of-Phase Power Divider with High Power-Handling Capability

Wideband Single-Ended-to-Balanced Power Divider with Intrinsic Common-Mode Suppression

Compact Design of Dual-Band Power Divider with Coupled-Line Shunt Elements

A Novel Harmonics-Suppression Coupled-Line Gysel Power Divider for Complex Terminated Impedances

A Balanced Tri-band PD Based on Microstrip-slotline Transition Structure Embedded Complementary Split-ring Resonators

Design of Reduced-Size Unequal Power Divider for Dual-Band Operation with Coupled Lines

A BROADBAND OUT-OF-PHASE POWER DIVIDER FOR HIGH POWER APPLICATIONS USING THROUGH GROUND VIA (TGV)

A Novel Reconfigurable Three-Way Power Divider Constructed on Unitary Plane

Design of Compact Dual-Band Power Dividers with Frequency-Dependent Division Ratios Based on Multisection Coupled Line

A 10:1 Unequal Wilkinson Power Divider Using Coupled Lines with Two Shorts

Wideband three-way power divider with bandpass filtering response using unequal-width three-coupled line

A Novel Unequal Broadband Out-of-Phase Power Divider Using DSPSLs

Dual-band equal/unequal Wilkinson power dividers based on coupled-line section with short-circuited stub

Novel design of compact quad‐band divider using stepped impedance coupled lines