Abstract:A new theory of designing dual-band power divider (PD) based on Wilkinson structure is presented in this paper. Because of the utilization of coupled lines, the proposed PD is with a high design freedom that many transmission line (TL) combinations can be used for a fixed frequency ratio k (f(2)/f(1)). Meanwhile, since the lengths of the conventional coupled lines used are extremely long, the slow-wave structure is introduced, which configuration results in a property of designable length and compact size because of the improved space efficiency. After analysing the even- and odd-mode circuits, precise design formulas are derived and further verified for the frequency ratio from 1.5 to 6.0 using NI AWR simulator under the consideration of the largest realizable TL impedance as 128 Omega. For verification, two PDs with the same centre frequency of 1.0 GHz and 4.0 GHz but different TL configurations are designed based on the proposed design theory. According to the experimental results, both fabricated PDs have good performances as expected, such as low in-band insertion loss (S-21), wide isolation, and relatively better out-of-band rejection than majority of previous studies that the maximum S-21 between the two passbands is larger than 6 dB, while previous studies are around 4 dB.

Wideband Single-Ended-to-Balanced Power Divider with Intrinsic Common-Mode Suppression

A Wideband Balanced-to-Unbalanced Out-of-Phase Power Divider Based on Hybrid Microstrip/Slotline Structure

A Half-Mode Substrate Integrated Waveguide Ring for Two-Way Power Division of Balanced Circuit

Multilayer Balanced-to-Unbalanced Power Divider with Wideband Transmission Characteristic and Common-Mode Suppression

Novel Planar Compact Coupled-Line Singleended-To-Balanced Power Divider

A Balanced Tri-band PD Based on Microstrip-slotline Transition Structure Embedded Complementary Split-ring Resonators

Compact Dual-Band Balanced-to-Unbalanced Filtering Power Divider Design With Extended \textCommon-Mode Suppression Bandwidth

Wideband three-way power divider with bandpass filtering response using unequal-width three-coupled line

Balanced Filtering Power Divider Based on Odd-mode Hybrid Microstrip and Slotline Spoof Surface Plasmon Polaritons

A Compact Meander Line-Resonator Hybrid Structure for Wideband Common-Mode Suppression

Extremely Compact Ultra-Wideband Power Divider Using Hybrid Slotline/microstrip-Line Transition

Wideband Out-Of-Phase Power Dividers With Improved Isolation Performance

A Dual-Band Balanced-To-Balanced Power Divider With High Selectivity And Wide Stopband

A Broadband Power Divider Based on Vertically Installed Planar Circuit Structure

Uwb Power Divider With One Narrow Notch-Band And Wide Stop-Band

Design of an Ultra-Wideband Power Divider with Good In-Band Performance and Sharp Roll-Off Skirt

Miniaturized Ultrawideband Reconfigurable Power Divider Based on Slotline and Double-Sided Parallel-Strip Line

Wideband Balanced Bandpass Filter with Common-Mode Noise Absorption Using Double-Sided Parallel-Strip Line

Design Method of Dual-Band Wilkinson Power Divider with Designable Length and High Design Freedom

An approach to 1-to-3 way microstrip balanced-to-balanced power divider/combiner

A Dual-Band Unequal Power Divider with Flexible Choice of Implementation