Abstract:In this paper, a wideband absorptive filtering power divider (AFPD) which features the characteristics of high selectivity and flat output distributions is proposed. It is composed of one unequal width three-coupled line (TCL), two coupled lines (CLs), two stepped open-circuited stubs, two kinds of isolation resistors, and two types of absorptive branches. The design equations of the proposed AFPD are derived using an even-odd decomposition method, and parametric investigations are also performed. It is found that the passband bandwidth can be adjusted by the stepped open-circuited stub which generates two transmission zeros (TZs). By combining the TCL with the CLs, the passband bandwidth is effectively enlarged. In addition, two isolated resistors are utilized for achieving good isolation and output-port matching performance. Without affecting the passband responses, the input port absorptive feature within the whole frequency band can be obtained by loading the absorptive branches both on the input and output ports. For validation, an example operating at the center frequency of 2 GHz was modeled and tested. Results exhibit that the passband FBW reaches 72% under 1 dB criterion, which illustrates flat output port distributions. In addition, for 10 dB return loss, the input and output impedance matching bandwidths are 250% and 78%, respectively. The features of good filtering responses are demonstrated by realizing the rectangle coefficient of 1.24 and the out-of-band suppression of more than 20 dB.

Wideband three-way power divider with bandpass filtering response using unequal-width three-coupled line

Wideband Four-Way Filtering Power Divider with Isolation Performance Using Three Parallel-Coupled Lines

Synthesis of miniaturized wideband four‐way filtering power divider consisting of unequal‐width three‐coupled‐lines

Exact synthesis of couple‐line based wideband four‐way filtering power divider with unequal power division

A Half-Mode Substrate Integrated Waveguide Ring for Two-Way Power Division of Balanced Circuit

A BROADBAND OUT-OF-PHASE POWER DIVIDER FOR HIGH POWER APPLICATIONS USING THROUGH GROUND VIA (TGV)

A Compact Gysel Power Divider with Unequal Power-Dividing Ratio Using One Resistor

Wideband Out-Of-Phase Power Dividers With Improved Isolation Performance

A Design of V-band Reconfigurable SPDT Switch/Power Divider Based on Slotted SIW

A Novel Unequal Broadband Out-of-Phase Power Divider Using DSPSLs

2n-Way Wideband Filtering Power Dividers With Good Isolation Enhanced by a Modified Isolation Network

Synthesis of Wideband All-Frequency Absorptive Filtering Power Divider with High Selectivity and Flat Output Port Distributions

A Novel Compact, Wideband Four-Way Wilkinson Power Divider with an Improved Isolation Topology

Compact Ultra-Wideband Wilkinson Power Divider in Parallel Stripline with Modified Isolation Branches

Design of n -Way Wideband Filtering Power Dividers With Good Port–Port Isolation

Wideband Single-Ended-to-Balanced Power Divider with Intrinsic Common-Mode Suppression

Compact Dual-Band Balanced-to-Unbalanced Filtering Power Divider Design With Extended \textCommon-Mode Suppression Bandwidth

Three-Way Substrate-Integrated Waveguide Filtering Power Divider with In-Phase and Anti-Phase Outputs

A Broadband Power Divider Based on Vertically Installed Planar Circuit Structure

A New Wideband Filtering Power Divider Based on Rectangle Patch Resonator with Compact Size

Dual-band equal/unequal Wilkinson power dividers based on coupled-line section with short-circuited stub