Abstract:A new theory of designing dual-band power divider (PD) based on Wilkinson structure is presented in this paper. Because of the utilization of coupled lines, the proposed PD is with a high design freedom that many transmission line (TL) combinations can be used for a fixed frequency ratio k (f(2)/f(1)). Meanwhile, since the lengths of the conventional coupled lines used are extremely long, the slow-wave structure is introduced, which configuration results in a property of designable length and compact size because of the improved space efficiency. After analysing the even- and odd-mode circuits, precise design formulas are derived and further verified for the frequency ratio from 1.5 to 6.0 using NI AWR simulator under the consideration of the largest realizable TL impedance as 128 Omega. For verification, two PDs with the same centre frequency of 1.0 GHz and 4.0 GHz but different TL configurations are designed based on the proposed design theory. According to the experimental results, both fabricated PDs have good performances as expected, such as low in-band insertion loss (S-21), wide isolation, and relatively better out-of-band rejection than majority of previous studies that the maximum S-21 between the two passbands is larger than 6 dB, while previous studies are around 4 dB.

A 10:1 Unequal Wilkinson Power Divider Using Coupled Lines with Two Shorts

A dual-band Wilkinson power divider with 6:1 power dividing ratio using coupled lines

Dual-band equal/unequal Wilkinson power dividers based on coupled-line section with short-circuited stub

A Compact Gysel Power Divider with Unequal Power-Dividing Ratio Using One Resistor

A Dual-Band Unequal Wilkinson Power Divider Using Asymmetric Coupled-Line

A Dual-Band Wilkinson Power Divider Using Dual Coupled Lines and Open Stubs

A tri-band Wilkinson power divider using extended T-shaped stubs

Analysis and design of a novel coupled-line wideband Wilkinson power divider

Novel Design of Wilkinson Power Dividers with Arbitrary Power Division Ratios

Novel Design of Dual-Band Unequal Wilkinson Power Divider

A Design Approach for Dual-Band Wilkinson Power Divider with Two Pairs of Coupled-Line Sections

Ultra‐wideband Power Divider Employing Coupled Line and Short‐ended Stub

Dual-band Wilkinson Power Divider Based on SS-CML

Novel Wilkinson Power Divider with Uniform Impedance Line

A new design of compact microstrip Wilkinson power dividers

W-band Power Divider Based on H-plane Slot Waveguide Bridge

A New Dual-Band Wilkinson Power Divider

Design of 1:3 unequal Wilkinson power divider with defected ground structure

Wilkinson Filtering Power Divider Using Coupled Lines and T‐shaped Stub

Shunt-stub Wilkinson Power Divider for Unequal Distribution Ratio

Design Method of Dual-Band Wilkinson Power Divider with Designable Length and High Design Freedom