Abstract:In this paper, we present a broadband out-of-phase power divider with high power-handling capability. The proposed device consists of several sections of double-sided parallel-strip lines (DSPSLs), a mid-inserted conductor plane, and two external isolation resistors, which are directly grounded for heat sinking. A through ground via (TGV), connecting the top and bottom sides of DSPSLs, is employed. The special metal via is realized to short the isolation resistors at full-frequency band when the odd-mode is excited. Meanwhile, it can be ignored as the excitation is even-mode. This property is efficiently utilized to improve the bandwidth. To examine the proposed power divider in detail, a set of closed-form equations are derived. Meanwhile, the power operation analysis illustrates that the proposed power divider is a good candidate for high power applications. The design charts show that the proposed device can support a wide frequency ratio range (1-1.7). Furthermore, broadband responses can be obtained when proper frequency ratios are adopted. For verification, an experimental power divider operating at 1.25/1.75 GHz is implemented. The measured results exhibit a bandwidth of 44.3% with better than 15 dB return loss and 18 dB port isolation is achieved.

A dual-band Wilkinson power divider with 6:1 power dividing ratio using coupled lines

Dual-band equal/unequal Wilkinson power dividers based on coupled-line section with short-circuited stub

A 10:1 Unequal Wilkinson Power Divider Using Coupled Lines with Two Shorts

A Dual-Band Unequal Wilkinson Power Divider Using Asymmetric Coupled-Line

Dual-band Wilkinson Power Divider Based on SS-CML

A Compact Gysel Power Divider with Unequal Power-Dividing Ratio Using One Resistor

Compact Rat-Race Coupler with Double-Sided Parallel-Strip Line (DSPSL) for Dual-Band Arbitrary Power Divisions

A tri-band Wilkinson power divider using extended T-shaped stubs

Novel Design of Dual-Band Unequal Wilkinson Power Divider

Design of Reduced-Size Unequal Power Divider for Dual-Band Operation with Coupled Lines

Miniaturization of Rat-Race Coupler With Dual-Band Arbitrary Power Divisions Based on Stepped-Impedance Double-Sided Parallel-Strip Line

A Dual-Band Coupled-Line Coupler with an Arbitrary Coupling Coefficient

A Half-Mode Substrate Integrated Waveguide Ring for Two-Way Power Division of Balanced Circuit

W-band Power Divider Based on H-plane Slot Waveguide Bridge

Design of Compact Dual-Band Power Dividers with Frequency-Dependent Division Ratios Based on Multisection Coupled Line

Novel Dual-Band Out-of-Phase Power Divider with High Power-Handling Capability

A BROADBAND OUT-OF-PHASE POWER DIVIDER FOR HIGH POWER APPLICATIONS USING THROUGH GROUND VIA (TGV)

Compact Design of Dual-Band Power Divider with Coupled-Line Shunt Elements

Novel design of compact quad‐band divider using stepped impedance coupled lines

A Synthesis Method for N-Section Unequal Ultra-Wideband Wilkinson Power Divider With Controllable Equal-Ripple Performance

Compact Ultra-Wideband Wilkinson Power Divider in Parallel Stripline with Modified Isolation Branches