Abstract:Display Omitted We develop a single-side microcavity-diaphragm-channel one-step formation process.Small sized piezoresistor-based micro flow-sensor is fabricated with the low-cost, high-yield technique.The IC-foundry compatible bulk-micromachining process has been transferred to a foundry company.The fabricated micro flow-sensor can be directly packaged into microfluidic systems with SMT technology.The micro flow-sensor exhibits high performance. A novel low-cost and high-yield fabrication method for piezoresistor-based micro flow sensor is presented and developed. The IC-foundry-compatible microcavity-diaphragm-channel one-step formation process is implemented only from the front-side of a single (111) silicon wafer to facilitate the micro flow sensor directly packaged into microfluidic systems with low cost surface mounting technology (SMT). With only one lithographic mask, this composite structure of the microcavity-diaphragm-channel is constructed by etching rows of microholes, coating the vertical microhole-sidewall, removing the coating at the microhole-bottom, defining the sacrificial gap and lateral underetch release along {110} and {211} orientations. Finally, the composite structure can be sealed by depositing low-stress polysilicon to refilling the microholes, without the need for double-sided micromachining process, Cavity-SOI process, and wafer bonding technique. Based on the microcavity-diaphragm-channel structure, the micro flow sensor is fabricated and the performance is measured, exhibiting a sensitivity of 12.9mV (µL/min)-1 for a 0-6µLmin-1 measured range (under DC 5-V supply), non-linearity of about 0.2% FS, and the flow rate resolution better than 45nlmin-1. In addition to the advantages of the high-performance and low cost batch-fabrication, the microcavity-diaphragm-channel one-step formation process can be widely used to fabricate many other MEMS-based microfluidic structure.

Design and Manufacture of an Integrated Micro Flow Sensor with SU-8 Channel

Design And Simulation Of Pdms-Si Machined Micro-Liquid Flow Sensor

Design of Thermal Liquid Flow Microsensor

Design and Development of SU-8 Check Microvalve Based on MEMS Technique

SIMULATION AND MICRO-PIV RESEARCH ON CLASSICAL MICROCHANNEL FLOW

Monolithic Integration Of A Micromachined Flow Sensor Based On Post-Cmos

Design and Fabrication of a MEMS Temperature and Pressure Integrated Sensor with Back-Inlet Package Structure

Design and Simulation Analysis of Microscale Fluidic Flow Sensor

Simulation and optimization of a micro flow sensor

Optimization of Two-Element Flow Microsensors Using Quasi 3-D Numerical Electrothermal Analysis

Design and development of MEMS based beam-membrane structure flow sensor

A Three-Dimensional Integrated Micro Calorimetric Flow Sensor in CMOS MEMS Technology

PDMS Microchannel Fabrication Technique Based on Microwire-Molding

Fabrication of the PDMS-Glass Microfluidic Chip with Integrated Electrodes

Fluid Structure Interaction Analysis and Simulation of Micromachined Cantilever-Based Flow Sensor

A single-side microcavity-diaphragm-channel one-step formation method for low-cost and high-yield volume production of micro flow sensors

Design and Fabrication of a MEMS Flow Sensor and Its Application in Precise Liquid Dispensing

A Self-Packaged Thermal Flow Sensor by CMOS MEMS Technology

Fabrication and Numerical Analysis of PDMS Micromixer on Microfluidic Chip

A Comprehensive Study of a Micro-Channel Heat Sink Using Integrated Thin-Film Temperature Sensors.

Integrated membrane-free thermal flow sensor for silicon-on-glass microfluidics