Abstract:With the rapid development of key industries such as new energy vehicles, smart homes, smart phones and consumer grade drones, the demand for high performance miniature micro- pressure sensors is also growing promptly. At prssent, most of the pressure sensors of this type adopt a C-type structure, and the thickness of the sensitive diaphragm needs to be continuously thinned in order to improve the sensitivity of this type sensor, which leads to its sensitivity to etching errors and makes it difficult to ensure the linearity of the pressure sensor. Based on this, we designed a miniature micro-pressure half active Wheatstone bridge piezoresistive pressure sensor with C-type square diaphragm structure, whose area is reduced by shortening the number of leads and pads, through ion impantation on the surface of the diaphragm to create a piezoresistors, using deep reactive ion etching (DRIE) technology to release the pressure sensitive diaphragm with length of 460 μm × 460 μm, thinkness of 7.5 μm. The buried oxygen layer in the SOI(silicon on insulator) can play a role of stopping the etching, which assures the uniformity of the released sensitive diaphragm and the non-linear errors of the sensor while maintains its sensitivity. In this paper, the influence of piezoresistor position offset on the performance of the pressure sensor is analyzed by means of simulation, which improves the accuracy of the designed model and guarantees its performance parameters can meet the design indicators. Finally, the static characteristics of the sensor is calibrated. The experimental results show that the sensitivity of the sensor is up to 0.538 mV kPa-1/3.5 V in the range of 40 kPa at room temperature, and the non-linear error is only 0.386 % FS. This study provides some new ideas and references for the design work of high performance micro-pressure sensors.

Design, Fabrication, Testing and Mechanical Analysis of Bulk-Micromachined Flowmeters

Research and Fabrication of a Low-Cost Valveless Micropump Based on Piezoelectric Actuation

A Piezoelectric Micropumping Device

Simulation and Fabrication of SiO2-based Piezoresistive Microbridges for Chem/biosensors

PROGRESSES ON MICROMACHINED FLOW SENSORS BASED ON MEMS TECHNOLOGIES

A Gas Flow Measurement System Based on Lead Zirconate Titanate Piezoelectric Micromachined Ultrasonic Transducer

Micro Flow Sensor Based on Two Closely Spaced Amperometric Sensors

A Micromachined Single-Crystal Silicon Flow Sensor with a Cantilever Paddle

Monolithic Integration Of A Micromachined Flow Sensor Based On Post-Cmos

A Micromachined Resonant Micro-Pressure Sensor

Design of Thermal Liquid Flow Microsensor

A Flexible Flow Sensor System And Its Characteristics For Fluid Mechanics Measurements

Fabrication and characterization of high-sensitivity, wide-range, and flexible MEMS thermal flow velocity sensors

Modelling and Characterisation of a Micromachined Resonant Pressure Sensor with Piezoelectric Excitation and Sensing

A self-bended piezoresistive microcantilever flow sensor for low flow rate measurement

Characterization Of Micromachined Sensors For Nanoscale Detection

Highly Accurate Airflow Volumetric Flowmeters Via Pmuts Arrays Based on Transit Time

Design and fabrication of a tiny micro-pressure sensor with improved linearity and sensitivity

Structural Engineering in Piezoresistive Micropressure Sensors: A Focused Review

A Novel Pressure Microsensor with 30- $\mu \Hbox{m}$-Thick Diaphragm and Meander-Shaped Piezoresistors Partially Distributed on High-Stress Bulk Silicon Region

Simulations and Analysis of a Piezoelectric Micropump.