Abstract:This article presents a tiny-size and high-performance thermal gas flow sensor with suspended Si/ Si thermopile formed in an ordinary non-silicon-on-insulator (SOI) (111) silicon wafer. A front-side bulk micromachining technique is herein employed to form the proposed gas flow sensor without double-side fabrication process, wafer bonding, and cavity-SOI needed. To achieve high sensitivity and quick response time, the suspended single-crystalline Si/ Si thermocouple which shows significantly higher Seebeck coefficient and lower noise compared to that of the traditional polysilicon/ polysilicon thermocouple is first used to construct the flow sensor. And the fishbone-shaped suspended SiN dielectric membrane is designed to maximize the thermal resistance between the Si heater and the silicon substrate, reducing heat dissipation from the Si heater to the silicon substrate. In addition, using high heat-conductivity Au-film to connect the cold junction and the bulk silicon acting as a heat-sink not only increases the temperature difference between the hot junction and the cold junction but also reduces the complexity of the fabrication process. Thanks to the single-side micromachining process, the sensor chip size is as small as mm. Finally, the characterization of the fabricated gas flow sensor was evaluated, showing an ultrahigh normalization sensitivity of 5 V/sccm/W, a quick response time of 1.44 ms, and a minimum detectable flow velocity (MDFV) of 0.0083 sccm.

A self-bended piezoresistive microcantilever flow sensor for low flow rate measurement

Initial approach for all optical type silicon micro-mechanical flow sensor

Fabrication and characterization of SiO2 microcantilever for microsensor application

Fabrication and Characterization of Sio2 Microcantilever for High Sensitive Moisture Sensor

Micromachined SiO 2 microcantilever for high sensitive moisture sensor

Simulation and Design of Piezoelectric Microcantilever Chemical Sensors

A microcantilever-based gas flow sensor for flow rate and direction detection

A Micromachined Single-Crystal Silicon Flow Sensor with a Cantilever Paddle

Simulation of SiO2-based Piezoresistive Microcantilevers

Discussion on the optical-coupling in silicon optical-type micromechanical sensors

A MEMS-based Air Flow Sensor with a Free-standing Micro-cantilever Structure

Fabrication of SiO $_{2}$ Microcantilever Using Isotropic Etching With ICP

A Front-Side Released Single Crystalline Silicon Piezoresistive Microcantilever Sensor

Design of Piezoresistive Micro-Cantilever with Stress Concentration Regions

Bio-inspired flow rate sensor based on optical microfiber embedded soft film

Design of Thermal Liquid Flow Microsensor

A Low Spring Constant Piezoresistive Microcantilever for Biological Reagent Detection

Development of piezoelectric microcantilever flow sensor with wind-driven energy harvesting capability

Fabrication and characterization of high-sensitivity, wide-range, and flexible MEMS thermal flow velocity sensors

Design, Fabrication And Characterization Of A Two-Step Released Silicon Dioxide Piezoresistive Microcantilever Immunosensor

Single (111)-Wafer Single-Side Microfabrication of Suspended p + Si/n + Si Thermopile for Tiny-Size and High-Sensitivity Thermal Gas Flow Sensors