Abstract:This paper presents a monolithically integrated aptasensor composed of a piezoresistive microcantilever array and an on-chip signal processing circuit. Twelve microcantilevers, each of them embedded with a piezoresistor, form three sensors in a Wheatstone bridge configuration. The on-chip signal processing circuit consists of a multiplexer, a chopper instrumentation amplifier, a low-pass filter, a sigma-delta analog-to-digital converter, and a serial peripheral interface. Both the microcantilever array and the on-chip signal processing circuit were fabricated on the single-crystalline silicon device layer of a silicon-on-insulator (SOI) wafer with partially depleted (PD) CMOS technology followed by three micromachining processes. The integrated microcantilever sensor makes full use of the high gauge factor of single-crystalline silicon to achieve low parasitic, latch-up, and leakage current in the PD-SOI CMOS. A measured deflection sensitivity of 0.98 × 10 − 6 nm −1 and an output voltage fluctuation of less than 1 μV were obtained for the integrated microcantilever. A maximum gain of 134.97 and an input offset current of only 0.623 nA were acquired for the on-chip signal processing circuit. By functionalizing the measurement microcantilevers with a biotin-avidin system method, human IgG, abrin, and staphylococcus enterotoxin B (SEB) were detected at a limit of detection (LOD) of 48 pg/mL. Moreover, multichannel detection of the three integrated microcantilever aptasensors was also verified by detecting SEB. All these experimental results indicate that the design and process of monolithically integrated microcantilevers can meet the requirements of high-sensitivity detection of biomolecules.

Fabrication and Characterization of Sio2 Microcantilever for High Sensitive Moisture Sensor

Micromachined SiO 2 microcantilever for high sensitive moisture sensor

Fabrication and characterization of SiO2 microcantilever for microsensor application

Fabrication of SiO $_{2}$ Microcantilever Using Isotropic Etching With ICP

Moisture measurement using porous aluminum oxide coated microcantilevers

Simulation and Design of Piezoelectric Microcantilever Chemical Sensors

Al2O3-coated Microcantilevers for Detection of Moisture at Ppm Level

Simulation of SiO2-based Piezoresistive Microcantilevers

Highly Sensitive and Selective Fluoride Ion Sensors Based on Microcantilevers Modified with Hydrogels

Design, Fabrication And Characterization Of A Two-Step Released Silicon Dioxide Piezoresistive Microcantilever Immunosensor

A Front-Side Released Single Crystalline Silicon Piezoresistive Microcantilever Sensor

A Sensor Platform Based On Piezoresistive Cantilever

Design of Piezoresistive Micro-Cantilever with Stress Concentration Regions

Design of High-Sensitivity Cantilever and Its Monolithic Integration with CMOS Circuits

A Silicon Microcantilever Biosensor Fabricated on SOI Wafers Using a Two-Step Releasing Approach

A Monolithically Integrated Microcantilever Biosensor Based on Partially Depleted SOI CMOS Technology

Design and characterization of high-sensitivity cantilevers

From Ceramic Tube to Microcantilever: A New Strategy for Low Power, Fast Heating and High Integrated Metal Oxide Semiconductor Gas Sensor

Microcantilever Humidity Sensor Based On Embedded Nmosfet With < 100 >-Crystal-Orientation Channel

Development of A Cmos-Mems Rf-Aerogel-Based Capacitive Humidity Sensor

Fabrication and Characterization of a Polymer/Metal Bimorph Microcantilever for Ultrasensitive Thermal Sensing