Abstract:This paper presents a monolithically integrated aptasensor composed of a piezoresistive microcantilever array and an on-chip signal processing circuit. Twelve microcantilevers, each of them embedded with a piezoresistor, form three sensors in a Wheatstone bridge configuration. The on-chip signal processing circuit consists of a multiplexer, a chopper instrumentation amplifier, a low-pass filter, a sigma-delta analog-to-digital converter, and a serial peripheral interface. Both the microcantilever array and the on-chip signal processing circuit were fabricated on the single-crystalline silicon device layer of a silicon-on-insulator (SOI) wafer with partially depleted (PD) CMOS technology followed by three micromachining processes. The integrated microcantilever sensor makes full use of the high gauge factor of single-crystalline silicon to achieve low parasitic, latch-up, and leakage current in the PD-SOI CMOS. A measured deflection sensitivity of 0.98 × 10 − 6 nm −1 and an output voltage fluctuation of less than 1 μV were obtained for the integrated microcantilever. A maximum gain of 134.97 and an input offset current of only 0.623 nA were acquired for the on-chip signal processing circuit. By functionalizing the measurement microcantilevers with a biotin-avidin system method, human IgG, abrin, and staphylococcus enterotoxin B (SEB) were detected at a limit of detection (LOD) of 48 pg/mL. Moreover, multichannel detection of the three integrated microcantilever aptasensors was also verified by detecting SEB. All these experimental results indicate that the design and process of monolithically integrated microcantilevers can meet the requirements of high-sensitivity detection of biomolecules.

Fabrication of SiO $_{2}$ Microcantilever Using Isotropic Etching With ICP

Fabrication and characterization of SiO2 microcantilever for microsensor application

Fabrication and Characterization of Sio2 Microcantilever for High Sensitive Moisture Sensor

Micromachined SiO 2 microcantilever for high sensitive moisture sensor

Fabrication of microcoil/microsprings for novel chemical and biological sensing

Isotropic Etch for SiO2 Microcantilever Release with ICP System

Simulation and Design of Piezoelectric Microcantilever Chemical Sensors

Simulation of SiO2-based Piezoresistive Microcantilevers

A Silicon Microcantilever Biosensor Fabricated on SOI Wafers Using a Two-Step Releasing Approach

Simulation and Fabrication of SiO2-based Piezoresistive Microbridges for Chem/biosensors

Design, Fabrication And Characterization Of A Two-Step Released Silicon Dioxide Piezoresistive Microcantilever Immunosensor

Detection of Ph Variation Using Modified Microcantilever Sensors

A Front-Side Released Single Crystalline Silicon Piezoresistive Microcantilever Sensor

Fabrication of SiO2 micro-cantilever and its sensor application based on higher resonance modes

Characterizations of microcantilever chemical sensors based on SOI material - art. no. 68360S

Silicon Dioxide Microcantilever With Piezoresistive Element Integrated For Portable Ultraresoluble Gaseous Detection

Si Orientation Dependent Release of SiO2 Microcantilevers by Wet Chemical Etching Method

A Monolithically Integrated Microcantilever Biosensor Based on Partially Depleted SOI CMOS Technology

Chemical and Biological Sensors Based on Microcantilever Structure

Parylene-coated NMOSFET-embedded cantilevers for surface stress sensing in liquid environment.

Quad-cantilever microsensors with a low-cost single-sided micro-machining technique for trace chemical vapor detection