Abstract:This paper presents a monolithically integrated aptasensor composed of a piezoresistive microcantilever array and an on-chip signal processing circuit. Twelve microcantilevers, each of them embedded with a piezoresistor, form three sensors in a Wheatstone bridge configuration. The on-chip signal processing circuit consists of a multiplexer, a chopper instrumentation amplifier, a low-pass filter, a sigma-delta analog-to-digital converter, and a serial peripheral interface. Both the microcantilever array and the on-chip signal processing circuit were fabricated on the single-crystalline silicon device layer of a silicon-on-insulator (SOI) wafer with partially depleted (PD) CMOS technology followed by three micromachining processes. The integrated microcantilever sensor makes full use of the high gauge factor of single-crystalline silicon to achieve low parasitic, latch-up, and leakage current in the PD-SOI CMOS. A measured deflection sensitivity of 0.98 × 10 − 6 nm −1 and an output voltage fluctuation of less than 1 μV were obtained for the integrated microcantilever. A maximum gain of 134.97 and an input offset current of only 0.623 nA were acquired for the on-chip signal processing circuit. By functionalizing the measurement microcantilevers with a biotin-avidin system method, human IgG, abrin, and staphylococcus enterotoxin B (SEB) were detected at a limit of detection (LOD) of 48 pg/mL. Moreover, multichannel detection of the three integrated microcantilever aptasensors was also verified by detecting SEB. All these experimental results indicate that the design and process of monolithically integrated microcantilevers can meet the requirements of high-sensitivity detection of biomolecules.

A Front-Side Released Single Crystalline Silicon Piezoresistive Microcantilever Sensor

Fabrication and characterization of SiO2 microcantilever for microsensor application

Design, Fabrication And Characterization Of A Two-Step Released Silicon Dioxide Piezoresistive Microcantilever Immunosensor

A Silicon Microcantilever Biosensor Fabricated on SOI Wafers Using a Two-Step Releasing Approach

Fabrication of SiO $_{2}$ Microcantilever Using Isotropic Etching With ICP

Fabrication and Characterization of Sio2 Microcantilever for High Sensitive Moisture Sensor

Micromachined SiO 2 microcantilever for high sensitive moisture sensor

Simulation and Design of Piezoelectric Microcantilever Chemical Sensors

Simulation of SiO2-based Piezoresistive Microcantilevers

Simulation and Fabrication of SiO2-based Piezoresistive Microbridges for Chem/biosensors

Design of Piezoresistive Micro-Cantilever with Stress Concentration Regions

A Monolithically Integrated Microcantilever Biosensor Based on Partially Depleted SOI CMOS Technology

A Sensor Platform Based On Piezoresistive Cantilever

Characterizations of microcantilever chemical sensors based on SOI material - art. no. 68360S

Silicon Dioxide Microcantilever With Piezoresistive Element Integrated For Portable Ultraresoluble Gaseous Detection

Design of High-Sensitivity Cantilever and Its Monolithic Integration with CMOS Circuits

A Low Spring Constant Piezoresistive Microcantilever for Biological Reagent Detection

A self-bended piezoresistive microcantilever flow sensor for low flow rate measurement

Fabrication of a Novel Device by Release the Stress in a Reliable Way

Fabrication of silicon piezoresistive pressure sensor using a reliable wet etching process

A high-temperature silicon-on-insulator stress sensor