Abstract:This paper presents a monolithically integrated aptasensor composed of a piezoresistive microcantilever array and an on-chip signal processing circuit. Twelve microcantilevers, each of them embedded with a piezoresistor, form three sensors in a Wheatstone bridge configuration. The on-chip signal processing circuit consists of a multiplexer, a chopper instrumentation amplifier, a low-pass filter, a sigma-delta analog-to-digital converter, and a serial peripheral interface. Both the microcantilever array and the on-chip signal processing circuit were fabricated on the single-crystalline silicon device layer of a silicon-on-insulator (SOI) wafer with partially depleted (PD) CMOS technology followed by three micromachining processes. The integrated microcantilever sensor makes full use of the high gauge factor of single-crystalline silicon to achieve low parasitic, latch-up, and leakage current in the PD-SOI CMOS. A measured deflection sensitivity of 0.98 × 10 − 6 nm −1 and an output voltage fluctuation of less than 1 μV were obtained for the integrated microcantilever. A maximum gain of 134.97 and an input offset current of only 0.623 nA were acquired for the on-chip signal processing circuit. By functionalizing the measurement microcantilevers with a biotin-avidin system method, human IgG, abrin, and staphylococcus enterotoxin B (SEB) were detected at a limit of detection (LOD) of 48 pg/mL. Moreover, multichannel detection of the three integrated microcantilever aptasensors was also verified by detecting SEB. All these experimental results indicate that the design and process of monolithically integrated microcantilevers can meet the requirements of high-sensitivity detection of biomolecules.

Design, Fabrication And Characterization Of A Two-Step Released Silicon Dioxide Piezoresistive Microcantilever Immunosensor

Fabrication and characterization of SiO2 microcantilever for microsensor application

A Front-Side Released Single Crystalline Silicon Piezoresistive Microcantilever Sensor

Fabrication of SiO $_{2}$ Microcantilever Using Isotropic Etching With ICP

Fabrication and Characterization of Sio2 Microcantilever for High Sensitive Moisture Sensor

A Silicon Microcantilever Biosensor Fabricated on SOI Wafers Using a Two-Step Releasing Approach

Simulation and Design of Piezoelectric Microcantilever Chemical Sensors

Micromachined SiO 2 microcantilever for high sensitive moisture sensor

Simulation of SiO2-based Piezoresistive Microcantilevers

Simulation and Fabrication of SiO2-based Piezoresistive Microbridges for Chem/biosensors

Design of Piezoresistive Micro-Cantilever with Stress Concentration Regions

A Novel Micro-cantilever Array Immunosensor Based on Piezoelectric Scanning

A Monolithically Integrated Microcantilever Biosensor Based on Partially Depleted SOI CMOS Technology

Polymeric Flexible Immunosensor Based on Piezoresistive Micro-Cantilever with PEDOT/PSS Conductive Layer

Design and Optimization of Laminated Piezoresistive Microcantilever Sensors

A Theoretical Model for Surface-Stress Piezoresistive Microcantilever Biosensors with Discontinuous Layers

A Low Spring Constant Piezoresistive Microcantilever for Biological Reagent Detection

Design of High-Sensitivity Cantilever and Its Monolithic Integration with CMOS Circuits

Biochemical Sensors Based on Piezoresistive Microcantilevers

Detection of Abrin Using a Polymide-based Piezoresistive Microcantilever Biosensor