Abstract:This work proposes a liquid-metal-based calorimetric micro-flow sensor within a polydimethylsiloxane (PDMS) chip. It can measure the flow rate of fluid in microscale channels, with a range as low as several microliters per minute. This in-chip sensor is proposed to solve the issue of detecting the flow rate in microfluidic systems. To make the sensor compatible with PDMS microfluidic chips, low-melting-point gallium-based alloy and bismuth-based (bi-based) alloy are used to make the micro heater and bi-metal thermocouples, for these alloys can be easily injected into a PDMS chip to form electrodes. To minimize heat resistance (or temperature difference) between fluid and the detecting ends of thermocouples, these ends are directly exposed to liquid in the flow channel with the help of a special reversible bonding technology. Thermocouples are connected in parallel to improve the sensor's response. A novel method to bond and electrically connect the sensor to a PCB (print circuit board) is also elaborated. Since the calorimetric flow sensor is sensitive to heating power, fluid temperature and environment cooling, a dimensionless parameter less independent of these factors is deduced from heat transfer theory, and this idea is used in result processing to offset the bad effect. Experiments with pure water show that this sensor can be used to detect flow rates, with a resolution up to 4 μl/min/mV and a range of 12 μl/min in this case, and that at different heating powers, the thermal potential results vary significantly whereas the dimensionless results nearly keep the same. Present work indicates that this sensor has the potential to be integrated into a PDMS microfluidic system and to provide accurate and stable results if a dimensionless method is used in data processing.

Micro Flow Sensor Based on Two Closely Spaced Amperometric Sensors

Simulation Study Of Nano Aqueous Flow Sensor Based On Amperometric Measurement

A New Method for Flow Rate Measurement in Millimeter-Scale Pipes.

A Device and Method For Flowrate Measurement of Fluid in Small Channel Based on C~4D Technique

Electrochemical time of flight flow sensor

Measuring Flow Velocity Distribution in Microchannels Using Molecular Tracers

Design of Thermal Liquid Flow Microsensor

Method for Flow Measurement in Microfluidic Channels Based on Electrical Impedance Spectroscopy

Bio-inspired flow rate sensor based on optical microfiber embedded soft film

Non-Silicon MEMS Calorimetric Gas Flow Sensor

A liquid-metal-based microscale calorimetric in-chip flow sensor for flow rate measuring

A Polymeric Dual-Channel Amperometric Biosensor Chip Capable of Symmetrically Splitting Sample Bands for Parallel Micro Flow Injection Determination of Glucose and Lactate

SIMULATION AND MICRO-PIV RESEARCH ON CLASSICAL MICROCHANNEL FLOW

In-Channel Modification of Biosensor Electrodes Integrated on A Polycarbonate Microfluidic Chip for Micro Flow-Injection Amperometric Determination of Glucose

A Microfluidic Chip Capable of Switching W/O Droplets to Vertical Laminar Flow for Electrochemical Detection of Droplet Contents.

A Three-Dimensional Integrated Micro Calorimetric Flow Sensor in CMOS MEMS Technology

Anisotropic microfluidics and flow monitoring with a microchannel towards soft-matter sensing

Optofluidic Fabry–Pérot Cavity Biosensor with Integrated Flow-Through Micro-/Nanochannels

A microfluidic bio membrane for flow rate metering

Single Chip Sensing of Multiple Gas Flows

Investigation on the Effective Measures for Improving the Performance of Calorimetric Microflow Sensor