Abstract:This work proposes a liquid-metal-based calorimetric micro-flow sensor within a polydimethylsiloxane (PDMS) chip. It can measure the flow rate of fluid in microscale channels, with a range as low as several microliters per minute. This in-chip sensor is proposed to solve the issue of detecting the flow rate in microfluidic systems. To make the sensor compatible with PDMS microfluidic chips, low-melting-point gallium-based alloy and bismuth-based (bi-based) alloy are used to make the micro heater and bi-metal thermocouples, for these alloys can be easily injected into a PDMS chip to form electrodes. To minimize heat resistance (or temperature difference) between fluid and the detecting ends of thermocouples, these ends are directly exposed to liquid in the flow channel with the help of a special reversible bonding technology. Thermocouples are connected in parallel to improve the sensor's response. A novel method to bond and electrically connect the sensor to a PCB (print circuit board) is also elaborated. Since the calorimetric flow sensor is sensitive to heating power, fluid temperature and environment cooling, a dimensionless parameter less independent of these factors is deduced from heat transfer theory, and this idea is used in result processing to offset the bad effect. Experiments with pure water show that this sensor can be used to detect flow rates, with a resolution up to 4 μl/min/mV and a range of 12 μl/min in this case, and that at different heating powers, the thermal potential results vary significantly whereas the dimensionless results nearly keep the same. Present work indicates that this sensor has the potential to be integrated into a PDMS microfluidic system and to provide accurate and stable results if a dimensionless method is used in data processing.

Single Chip Sensing of Multiple Gas Flows

Optical Micro/nanofibre Embedded Soft Film Enables Multifunctional Flow Sensing in Microfluidic Chips

Non-Silicon MEMS Calorimetric Gas Flow Sensor

A C~4D-Based Measurement System of Gas-Liquid Two-Phase Flow

An Integrated Circuit Compatible Compact Package for Thermal Gas Flowmeters

Micro Flow Sensor Based on Two Closely Spaced Amperometric Sensors

Parameter Measurement System of Taylor Flow in Small Channels Based on Photodiode Array Sensors.

Single (111)-Wafer Single-Side Microfabrication of Suspended p + Si/n + Si Thermopile for Tiny-Size and High-Sensitivity Thermal Gas Flow Sensors

High Performance Bidirectional Thermal Gas Flow Sensor of (100) Silicon Single-Sided Fabrication by 45-Tilted Dicing

A liquid-metal-based microscale calorimetric in-chip flow sensor for flow rate measuring

Design of Thermal Liquid Flow Microsensor

Microfluidic Flowmeter Based on Micro "Hot-Wire" Sandwiched Fabry-Perot Interferometer.

A microcantilever-based gas flow sensor for flow rate and direction detection

A Three-Dimensional Integrated Micro Calorimetric Flow Sensor in CMOS MEMS Technology

Thermal Gas Flow Measurement Based on Single Sensor

Characterization and Design Evaluation of Membrane-Based Calorimetric MEMS Sensors for Two-Dimensional Flow Measurement

Gas–Liquid Flow Rate Measurement Using a Twin-Plane Capacitive Sensor and a Venturi Meter

Hot-wire Sandwiched Fabry-Perot Interferometer for Microfluidic Flow Rate Sensing

A Device and Method For Flowrate Measurement of Fluid in Small Channel Based on C~4D Technique

A Front-Side Microfabricated Thermoresistive Gas Flow Sensor for High-Performance, Low-Cost and High-Yield Volume Production

Fully Integrated Bidirectional CMOS-MEMS Flow Sensor With Low Power Pulse Operation