Abstract:Aiming at the shortcomings of the traditional engineering experience in designing thin-film heat flow meters, such as low precision and long iteration time, the finite element analysis model of thin-film heat flow meters is established based on finite element simulation methods, and a double-type thin-film heat flow sensor based on a copper/concentrate thermopile is made. The influence of the position of the thermal resistance layer, heat flux density and thickness of the thermal resistance layer on the temperature gradient of the hot and cold ends of the heat flow sensor were comprehensively analyzed by using a simulation method. When the applied heat flux density is 50 kW/m2 and the thermal resistance layer is located above and below the thermopile, respectively, the temperature difference between the hot junction and the cold junction is basically the same, but comparing the two, the thermal resistance layer located above is more suitable for rapid measurements of heat flux at high temperatures. In addition, the temperature difference between the hot and cold contacts of the thin-film heat flux sensor increases linearly with the thickness of the thermal resistance layer. Finally, we experimentally tested the response–recovery characteristics of the sensors, with a noise of 2.1 μV and a maximum voltage output of 15 μV in a room temperature environment, respectively, with a response time of about 2 s and a recovery time of about 3 s. Therefore, the device we designed has the characteristic of double-sided use, which can greatly expand the scope of use and service life of the device and promote the development of a new type of heat flow meter, which will provide a new method for the measurement of heat flow density in the complex environment on the surface of the aero-engine.

Characterization and Design Evaluation of Membrane-Based Calorimetric MEMS Sensors for Two-Dimensional Flow Measurement

Design of Thermal Liquid Flow Microsensor

Non-Silicon MEMS Calorimetric Gas Flow Sensor

MEMS Flow Sensors Based on Self-Heated aGe-Thermistors in a Wheatstone Bridge

A Three-Dimensional Integrated Micro Calorimetric Flow Sensor in CMOS MEMS Technology

Design and Modeling of Vanadium Dioxide-Based High-Sensitivity Microfluidic Calorimetric Sensors

Fabrication and characterization of high-sensitivity, wide-range, and flexible MEMS thermal flow velocity sensors

A Compact Flexible Thermal Flow Sensor for Detecting Two-Dimensional Flow Vector

Development of an Energy-Efficient and Highly Sensitive Thermal Microsensor for Measuring Flow Rates of Fluids

A two-dimensional flow sensor with integrated micro thermal sensing elements and a back propagation neural network

A liquid-metal-based microscale calorimetric in-chip flow sensor for flow rate measuring

High Performance Bidirectional Thermal Gas Flow Sensor of (100) Silicon Single-Sided Fabrication by 45-Tilted Dicing

Structural Design of Dual-Type Thin-Film Thermopiles and Their Heat Flow Sensitivity Performance

Nickel Membrane Temperature Sensor in Micro-Flow Measurement

The Development and Application of Microthermal Sensors with A Mesh-Membrane Supporting Structure

A Novel Vanadium Dioxide-Based Dual-Heater Microfluidic Thermal Flow Sensor with Record High Sensitivity

Single Chip Sensing of Multiple Gas Flows

Vanadium Dioxide-Based High Sensitivity Dual-Heater Calorimetric Microfluidic Sensor

A numerical investigation of conjugate forced heat transfer for a micro thermal flow sensor

Integrated membrane-free thermal flow sensor for silicon-on-glass microfluidics

Systematic Study of Packaging Designs on the Performance of CMOS Thermoresistive Micro Calorimetric Flow Sensors