Abstract:This work proposes a liquid-metal-based calorimetric micro-flow sensor within a polydimethylsiloxane (PDMS) chip. It can measure the flow rate of fluid in microscale channels, with a range as low as several microliters per minute. This in-chip sensor is proposed to solve the issue of detecting the flow rate in microfluidic systems. To make the sensor compatible with PDMS microfluidic chips, low-melting-point gallium-based alloy and bismuth-based (bi-based) alloy are used to make the micro heater and bi-metal thermocouples, for these alloys can be easily injected into a PDMS chip to form electrodes. To minimize heat resistance (or temperature difference) between fluid and the detecting ends of thermocouples, these ends are directly exposed to liquid in the flow channel with the help of a special reversible bonding technology. Thermocouples are connected in parallel to improve the sensor's response. A novel method to bond and electrically connect the sensor to a PCB (print circuit board) is also elaborated. Since the calorimetric flow sensor is sensitive to heating power, fluid temperature and environment cooling, a dimensionless parameter less independent of these factors is deduced from heat transfer theory, and this idea is used in result processing to offset the bad effect. Experiments with pure water show that this sensor can be used to detect flow rates, with a resolution up to 4 μl/min/mV and a range of 12 μl/min in this case, and that at different heating powers, the thermal potential results vary significantly whereas the dimensionless results nearly keep the same. Present work indicates that this sensor has the potential to be integrated into a PDMS microfluidic system and to provide accurate and stable results if a dimensionless method is used in data processing.

Non-Silicon MEMS Calorimetric Gas Flow Sensor

Design of Thermal Liquid Flow Microsensor

A Three-Dimensional Integrated Micro Calorimetric Flow Sensor in CMOS MEMS Technology

Development of a Gas Flow Sensor Based on FS5 Hot-Film Probe

The Research on the Gas Sensor Based on LAPS and Nanometer Porous Silicon

High Performance Bidirectional Thermal Gas Flow Sensor of (100) Silicon Single-Sided Fabrication by 45-Tilted Dicing

A liquid-metal-based microscale calorimetric in-chip flow sensor for flow rate measuring

Design and Modeling of Vanadium Dioxide-Based High-Sensitivity Microfluidic Calorimetric Sensors

Study on new gas flow sensor based on hot-film probe

Thermal Gas Flow Measurement Based on Single Sensor

Single Chip Sensing of Multiple Gas Flows

Single (111)-Wafer Single-Side Microfabrication of Suspended p + Si/n + Si Thermopile for Tiny-Size and High-Sensitivity Thermal Gas Flow Sensors

Fully Integrated Bidirectional CMOS-MEMS Flow Sensor With Low Power Pulse Operation

Micro Flow Sensor Based on Two Closely Spaced Amperometric Sensors

Characterization and Design Evaluation of Membrane-Based Calorimetric MEMS Sensors for Two-Dimensional Flow Measurement

From Ceramic Tube to Microcantilever: A New Strategy for Low Power, Fast Heating and High Integrated Metal Oxide Semiconductor Gas Sensor

Vanadium Dioxide-Based High Sensitivity Dual-Heater Calorimetric Microfluidic Sensor

Fabrication and characterization of high-sensitivity, wide-range, and flexible MEMS thermal flow velocity sensors

Development of an Energy-Efficient and Highly Sensitive Thermal Microsensor for Measuring Flow Rates of Fluids

MEMS Flow Sensors Based on Self-Heated aGe-Thermistors in a Wheatstone Bridge

Research On Thermal Conductivity Measurement Of Submicrometer-Scale Silicon Dioxide Film In Thermal Flow Sensor By Micro-Raman Technique