Abstract:This article presents a tiny-size and high-performance thermal gas flow sensor with suspended Si/ Si thermopile formed in an ordinary non-silicon-on-insulator (SOI) (111) silicon wafer. A front-side bulk micromachining technique is herein employed to form the proposed gas flow sensor without double-side fabrication process, wafer bonding, and cavity-SOI needed. To achieve high sensitivity and quick response time, the suspended single-crystalline Si/ Si thermocouple which shows significantly higher Seebeck coefficient and lower noise compared to that of the traditional polysilicon/ polysilicon thermocouple is first used to construct the flow sensor. And the fishbone-shaped suspended SiN dielectric membrane is designed to maximize the thermal resistance between the Si heater and the silicon substrate, reducing heat dissipation from the Si heater to the silicon substrate. In addition, using high heat-conductivity Au-film to connect the cold junction and the bulk silicon acting as a heat-sink not only increases the temperature difference between the hot junction and the cold junction but also reduces the complexity of the fabrication process. Thanks to the single-side micromachining process, the sensor chip size is as small as mm. Finally, the characterization of the fabricated gas flow sensor was evaluated, showing an ultrahigh normalization sensitivity of 5 V/sccm/W, a quick response time of 1.44 ms, and a minimum detectable flow velocity (MDFV) of 0.0083 sccm.

High Performance Bidirectional Thermal Gas Flow Sensor of (100) Silicon Single-Sided Fabrication by 45-Tilted Dicing

A Front-Side Microfabricated Thermoresistive Gas Flow Sensor for High-Performance, Low-Cost and High-Yield Volume Production

Non-Silicon MEMS Calorimetric Gas Flow Sensor

Single (111)-Wafer Single-Side Microfabrication of Suspended p + Si/n + Si Thermopile for Tiny-Size and High-Sensitivity Thermal Gas Flow Sensors

Performance Enhanced Thermal Flow Sensor with Novel Dual-Heater Structure Using CMOS Compatible Fabrication Process

Single-Side Fabricated P(+)Si/Al Thermopile-Based Gas Flow Sensor For Ic-Foundry-Compatible, High-Yield, And Low-Cost Volume Manufacturing

Micro-flow Sensor for Opto-pneumatic Detection

Design of Thermal Liquid Flow Microsensor

A Novel Vanadium Dioxide-Based Dual-Heater Microfluidic Thermal Flow Sensor with Record High Sensitivity

A High Heat Transfer Efficiency MEMS Thermal Conductivity Gas Sensor with Bridge Structure for Hydrogen Detection

Thermal Gas Flow Measurement Based on Single Sensor

A Self-Packaged Thermal Flow Sensor by CMOS MEMS Technology

A micro channel integrated gas flow sensor for high sensitivity

Fabrication and characterization of high-sensitivity, wide-range, and flexible MEMS thermal flow velocity sensors

Novel Cmos Two-Dimensional Integrated Gas Flow Sensor

From Ceramic Tube to Microcantilever: A New Strategy for Low Power, Fast Heating and High Integrated Metal Oxide Semiconductor Gas Sensor

A microcantilever-based gas flow sensor for flow rate and direction detection

Monolithic Integration of a Flexible Micro Thermal Flow Sensor

Thermal Conductivity Gas Sensor with Enhanced Flow-Rate Independence

Development of A Self-Packaged 2d Mems Thermal Wind Sensor for Low Power Applications

A Three-Dimensional Integrated Micro Calorimetric Flow Sensor in CMOS MEMS Technology