Abstract:The demand for microfluidic pressure sensors is ever-increasing in various industries due to their crucial role in controlling fluid pressure within microchannels. While syringe pump setups have been traditionally used to regulate fluid pressure in microfluidic devices, they often result in larger setups that increase the cost of the device. To address this challenge and miniaturize the syringe pump setup, the researcher introduced integrated T-microcantilever-based microfluidic devices. In these devices, microcantilevers are incorporated, and their deflections correlate with the microchannel's pressure. When the relative pressure of fluid (plasma) changes, the T-microcantilever deflects, and the extent of this deflection provides information on fluid pressure within the microchannel. In this work, finite element method (FEM) based simulation was carried out to investigate the role of material, and geometric parameters of the cantilever, and the fluid viscosity on the pressure sensing capability of the T-microcantilever integrated microfluidic channel. The T-microcantilever achieves a maximum deflection of 127μm at a 5000μm/s velocity for Young's modulus(E) of 360 kPa of PDMS by employing a hinged structure. On the other hand, a minimum deflection of 4.05 × 10-5μm was attained at 5000μm/s for Young's modulus of 1 TPa for silicon. The maximum deflected angle of the T-cantilever is 20.46° for a 360 kPa Young's modulus while the minimum deflection angle of the T-cantilever is measured at 13.77° for 900 KPa at a fluid velocity of 5000μm s-1. The T-cantilever functions as a built-in microchannel that gauges the fluid pressure within the microchannel. The peak pressure, set at 8.86 Pa on the surface of the cantilever leads to a maximum deflection of 0.096μm (approximately 1μm) in the T-cantilever at a 1:1 velocity ratio. An optimized microfluidic device embedded with microchannels can optimize fluid pressure in a microchannel support cell separation.

On-chip micro pressure sensor for microfluidic pressure monitoring

Micro-pressure Sensor Made of Conductive PDMS for Microfluidic Applications

A Capacitive Pressure Sensor Seamlessly Embedded in the Microchannel

A Liquid Metal Based Capacitive Soft Pressure Microsensor.

A chip-integrated optical microfluidic pressure sensor

A Smart Microfluidic System Integrated with Pressure Sensors and Flow Sensor Based on Electrochemical Impedance Methods

Ultraminiature and Flexible Sensor Based on Interior Corner Flow for Direct Pressure Sensing in Biofluids.

Study on a multi-channel micro fluid chip pressure measurement method based on laminar flow distribution

Various On-Chip Sensors with Microfluidics for Biological Applications

Various on-chip sensors with microfluidics for biological applications.

Pressure Measurement Methods in Microchannels: Advances and Applications

Optofluidic Membrane Interferometer: An Imaging Method For Measuring Microfluidic Pressure And Flow Rate Simultaneously On A Chip

Principle and Application of Silicion Micromachined Fluid Sensor Based on MEMS

Application of Embedded Capacitive Pressure Sensors in Pressure Drop Measurement of Microchannels

High-Sensitivity Microfluidic Pressure Sensor Using A Membrane-Embedded Resonant Optical Grating

MICRODROPLET INTERFEROMETRY FOR LOCAL PRESSURE MONITORING IN MICROFLUIDIC CHIPS

Integrated High-Speed Flow Sensor Based on Pressure Difference Measuring

Optimization of Newtonian fluid pressure in microcantilever integrated flexible microfluidic channel for healthcare application

Wearable Microfluidic Diaphragm Pressure Sensor for Health and Tactile Touch Monitoring

Design and fabrication of a microfluidic detection chip

A Micro Flow Sensor for Volumetric Measurement of Conductive Fluids